Abstract:The rotating stall inception point predicted by linear theories is at the peak of axisymmetric characteristic of the compressor. But this may not be true in practice. High speed compressors and some low speed compressors are observed experimentally to lose their stability at the region where the performance curves of the compressor has negative slope. In this paper, the Lyapunov direct method is used to prove that in a compression system an asymptotically stable operating point close to the peak of the axisymmetric characteristic of the compressor could be nonlinearly unstable. Moreover, it is proposed that the nonaxisymmetric disturbance is able to be eliminated by only detecting and controlling the mean axial velocity. The axial flow compression system is modeled by an one-mode truncated Moore-Greitzer model. The analysis is concentrated on the cases in which the system is predicted by the linear theory to be asymptotically stable. It is found that there are two cases which are asymptotically stable but nonlinearly unstable. First, when the steepness of the compressor characteristic, measured by parameter S, and the Greitzer's B parameter are small, rotating stall occurs if the amplitude of initial nonaxisymmetric disturbance is over a certain value. Second, when parameter S and the Greitzer's B parameter are large, the system surges over one cycle under the influence of a very small initial nonaxisymmetric disturbance whose amplitude is about ten times less than the limit value of the first case. These results are very important for the design of an active controller to improve the efficiency of the compression systems. 'Copyright @ 1995 by the American Institute of Aeronautics and Astronautics, Inc. All rights reserved. tAIAA member, Current position: Assistant Professor, Dept. of Mechanical Eng., Indiana Institute of Technology, Fort Wayne, IN46803 * Associate Professor NOMENCLATURE

Effect of Blade Loading Distribution on Flow Stability of Axial Compressor

Effect of Rotor Axial Blade Loading Distribution on Compressor Stability

Effect of rotor blade loading distribution on flow stability of transonic compressor

Stall Inception Analysis on Axial Compressors with Different Rotor Loading Distributions under Radial Inlet Distortions

Theoretical and experimental investigation on the stall inception of low-speed axial compressors with swept rotor blades

Aerodynamic Instabilities of Swept Airfoil Design in Transonic Axial-Flow Compressors

Mechanism Investigation of Enhancing the Stability of an Axial Flow Rotor by Blade Angle Slots

Exploration of Flow Instability Characteristics in a Two-Stage Axial-Flow Compressor Via Numerical Simulation Method

Effect of fore/aft-loaded rotor on compressor stability under inlet circumferential distortion

Flow Stability Analysis on Low-Speed Compressor with Swept Rotor Blades under Radial Inlet Distortions

A Theoretical Model For Flow Instability Inception In Transonic Fan/Compressors

Comparing Effects of Blade Surface with Those of End-Wall Boundary Layer Suction(BLS) on Stability of Transonic Compressor

Analysis on Effects of Combined Boundary Layer Suction for Transonic Compressor Stability

Nonlinear Instability of Axial Flow Compression Systems

Calculation of Flow Instability Inception in High Speed Axial Compressors Based on an Eigenvalue Theory

Research Progress in Prediction of Flow Instability of Aero-Compressor

Numerical Investigation of the Influence of Axial Overlap of Blade Angle Slots on an Axial Flow Compressor Stability

Effects of the Radial Blade Loading Distribution and B Parameter on the Type of Flow Instability in a Low-Speed Axial Compressor

Experimental Study of Blade Hub Loading Effects on Instability Evolution in a Low-Speed Compressor

Application of Complex 3D Aerodynamic Layout in Highly Loaded Compressor on Numerical Simulation

Sensitivity Analysis for Flow Stability of Axial Compressor Based on Meridional Flow