Abstract:Compressor characteristics and system parameters, which include pipe lengths, plenum volumes, and throttle coefficients, greatly affect compressor surge. The one-dimensional-three-dimensional (1D-3D) coupled method, is established in Part 1, combines a 3D solver for compressor internal flows and a 1D solver for pipe, plenum, and throttle flows to simulate compressor surge in a compression system. In this paper, the capability of the method to reflect changes of compressor characteristics and system parameters will be demonstrated. Given a centrifugal compressor, variable inlet prewhirl and variable diffuser vanes are employed to adjust compressor characteristics; based on the setup of a datum test rig, the pipe length, plenum volume and throttle coefficient in the 1D solver are modified to get different system setups. Thus, the compressor system can be numerically configured with various compressor characteristics and system parameters, and the 1D-3D coupled method is applied to simulate compressor surge in various configurations. Simulation results show that compressor surge flow rates decrease, and surge periods prolong in the case of positive inlet prewhirl, which is consistent with known results concerning inlet prewhirl; if the diffuser vanes are closed by 5 degrees, the compressor would get out of surge and operate stably, which aligns with expectations. In terms of system parameters, simulation results indicate that the surge period is shortened and the trajectory of surge cycle on the performance map shrinks if the pipe length or plenum volume reduces. Mild surge, mixed surge, and deep surge are captured while the throttle is set with big, moderate and small openings, respectively. Thus, the 1D-3D coupled method is proved being sensitive to changes of compressor characteristics and system parameters, justifying using the 1D-3D coupled method to explore several research topics concerning compressor characteristics and system parameters in compressor surge. This paper lays a foundation of using the 1D-3D coupled method to investigate the relation between compressor surge and stall, compressor surge in a dynamic compression system, structures and dynamics during compressor surge, and the flow instability boundary.

Aerodynamic Instability Evolution of a Multi-Stage Combined Compressor

Surge Process of a High-Speed Axial–Centrifugal Compressor

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Experimental Investigation on the Aerodynamic Instability Process of a High-Speed Axial-Centrifugal Compressor

Flow Physics During Surge of an Axial-Centrifugal Compressor

INVESTIGATION ON THE UNSTEADY SURGE FLOW BEHAVIOR OF AN AXIAL-CENTRIFUGAL COMPRESSOR

Compressor Stability at Pulsating Condition Via Gas Dynamics Responses Analysis

Numerical Investigation on Rotating Instability in a Multistage Axial-Radial Combined Compressor

Flow Instability Evolution in High Pressure Ratio Centrifugal Compressor with Vaned Diffuser

Nonlinear Instability of Axial Flow Compression Systems

Investigation of the Mild Surge in an Axial–centrifugal Compressor

Experimental Investigation of Surge and Stall in a High-Speed Centrifugal Compressor

Two-Regime Surge Mechanism in Centrifugal Compressors

Numerical Investigation of Flow Evolution in Centrifugal Compressors During Surge

Phenomenon and Mechanism of Two-Regime-Surge in a Centrifugal Compressor

A numerical study of multistage axial compressor stability

Full Annulus Simulation on a Multistage Axial-Centrifugal Combined Compressor

Investigation of the Instability Mechanisms in a Turbocharger Centrifugal Compressor with a Vaneless Diffuser by Means of Unsteady Simulations

Research on the Instability of Centrifugal Compressors

Generation Mechanisms of Rotating Stall and Surge in Centrifugal Compressors

Compressor Surge Based on a 1D-3D Coupled Method – Part 2: Surge Investigation