Abstract:Rotating stall is one of the most important sources of performance deterioration and system instability in axial flow compressors and, therefore, it is of great value for compressor aerodynamic design and the development of active control strategies. It has been widely demonstrated that peculiar flow mechanisms, such as tip clearance leakage vortices, play a decisive role in the genesis of rotating instabilities (RI) and stall inception, however it is still very hard to predict and interpret such mechanisms accurately. This paper presents the results of both experimental and numerical researches dealing with forming process of rotating stall in a 1.5-stage low-speed industrial axial compressor at Harbin Engineering University. A new physical mechanism for explaining the birth of rotating instabilities based on the detection of spike waves is introduced as a result of a deep analysis recognising the role due to low-energy flow migration of along the rotor spanwise direction. To this purpose, transient pressure signals obtained from both experiments and simulations were adopted to describe flow details during onset and scanning pressure contours on the compressor casing were obtained both experimentally and numerically during the process of approaching stall point so that the transition process from RI to the appearance of spike waves could be well captured. The experimental results showed that the frequencies of RI dropped nearly linearly against the flow coefficient and the strength of radial secondary flows increased distinctly, which induces the boundary layer separation near leading edge in the tip region at last. Full-annulus URANS numerical simulations using SST turbulence model were performed and validated adequately by test data, and then employed to capture more flow details and support better understanding of the flow physics. In fact, a lateral tornado-type vortex occurring before the trailing edge backflow and featuring the same frequency of early pressure disturbances was observed numerically. Under the combined effect of the lateral tornado-type vortex and the tip secondary vortex, a trailing edge reverse flow was observed which produced a huge increase of blockage. A radial tornado vortex was formed connecting the suction side and casing wall at the same time finally leading to the spike-wave rotating stall.

Numerical Investigation on Rotating Instability in a Multistage Axial-Radial Combined Compressor

Numerical Investigations of Rotating Instability and Unsteady Tip Vortex Structures in an Axial Compressor

Experimental study on rotating instability mode characteristics of axial compressor tip flow

Investigation on Rotating Instability in an Axial Compressor with Different Inlet Reynolds Numbers

Investigation of Rotating Instability Characteristics in an Axial Compressor with Different Tip Clearances

Investigations of Rotating Instability and Fluctuating Tip Clearance Flow in a Low-Speed Axial Compressor

Aerodynamic Instability Evolution of a Multi-Stage Combined Compressor

Experimental Investigation on the Aerodynamic Instability Process of a High-Speed Axial-Centrifugal Compressor

Numerical Investigation on the Flow Mechanism of Multi-Peak Frequency Feature of Rotating Instability

The Investigation of Axial Compressor With Aggressive Flow Path Near Stall Condition

Circumferential Mode Analysis of Axial Compressor Tip Flow Using Fourier Transform and Proper Orthogonal Decomposition

Nonlinear Instability of Axial Flow Compression Systems

Modal Analysis of Axial Compressor Tip Rotating Instability under Varying Operating Conditions

The role of radial secondary flow in the process of rotating stall for a 1.5-stage axial compressor

Full Annulus Simulation on a Multistage Axial-Centrifugal Combined Compressor

Evolution of the Flow Instabilities in an Axial Compressor Rotor with Large Tip Clearance: an Experimental and URANS Study

Exploration of Flow Instability Characteristics in a Two-Stage Axial-Flow Compressor Via Numerical Simulation Method

Experimental investigation of flow instability evolution in a low-speed two-stage axial compressor

Tip leakage flow, tip aerodynamic loading and rotating instability in a subsonic high-speed axial flow compressor rotor

Investigation of tip leakage flow unsteadiness and rotating instability in a centrifugal compressor impeller

Investigation on Mode Characteristics of Rotating Instability and Rotating Stall in an Axial Compressor