Abstract:The centrifugal compressor is widely used for gas compression in various industrial fields such as aero-engine, gas turbine and turbocharger. However, the stable operating range is usually restricted by the occurrence of flow instability such as stall and surge. The paper experimentally examines the developing process of surge and stall occurring in a centrifugal compressor to advance the understanding on flow mechanism of flow instability. It is found that three types of pressure fluctuation can be observed at low flowrate region. At the critical point, the local stall firstly occurs in some specific diffuser passages and the enlarged local diffuser stall eventually induces the mild surge of compression system indicated by the sinusoidal pressure fluctuation. At lower mass flow rate, the diffuser stall cell begins to circumferentially propagate along the impeller rotating direction at 11% of rotor speed with the existence of mild surge. In comparative analysis of IGV pre-swirl angle on the occurrence of mild surge, the mild surge still occurs at the operating condition when the slope of the characteristic map of test stage is still obviously negative, in which the compression system is supposed to be stable in previous study. And a new suggested criterion for the prediction of mild surge is demonstrated that the occurrence of mild surge depends on the destabi-lization effect of downstream components about diffuser and volute. Combined with the experimental data, the streamwise distribution characteristic of diffuser stall can be used to develop the simplified model of lumped parameters for the analysis on the generation mechanism of the diffuser rotating stall. The quantitative investigation on the relation between the pressure-rise characteristic of subcomponents and the occurrence of mild surge and diffuser rotating stall not only advances the prediction of stability limit but also lays the theoretic foundation for controlling these unsteady behaviors to improve the operating range.

A numerical study of multistage axial compressor stability

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Surge Process of a High-Speed Axial–Centrifugal Compressor

A Review on Theoretical and Numerical Research of Axial Compressor Surge

Stall Margin Improvement in an Axial Compressor by Continuous and Pulsed Tip Injection

Compressor Stability at Pulsating Condition Via Gas Dynamics Responses Analysis

A throughflow-based optimization method for multi-stage axial compressor

Aerodynamic Instability Evolution of a Multi-Stage Combined Compressor

INVESTIGATION ON THE UNSTEADY SURGE FLOW BEHAVIOR OF AN AXIAL-CENTRIFUGAL COMPRESSOR

Stator re-stagger optimization in multistage axial compressor

Numerical Investigation on Rotating Instability in a Multistage Axial-Radial Combined Compressor

Experimental Investigation on the Aerodynamic Instability Process of a High-Speed Axial-Centrifugal Compressor

Statistical evaluation of stability margin of a multi-stage compressor with geometric variability using adaptive polynomial chaos-Kriging model

Nonlinear Instability of Axial Flow Compression Systems

Active Surge Control for Variable Speed Axial Compressors.

Numerical Study of the Improvement in Stability and Performance by Use of a Partial Vaned Diffuser for a Centrifugal Compressor Stage

Numerical investigation of deep surge in a centrifugal compressor with vaned diffuser and large plenum

Flow Physics During Surge of an Axial-Centrifugal Compressor

Full Annulus Simulation on a Multistage Axial-Centrifugal Combined Compressor

Investigation of the Mild Surge in an Axial–centrifugal Compressor

Numerical investigation of the effects of system volume and average mass flow on the surge characteristics of an axial compressor