Influence of manufacturing errors on the aerodynamic working stability of axial flow compressors
Lingchen Kong,Xiangjun Li,Qing Lu,Zhengyu Zhu,Qian Zhou
DOI: https://doi.org/10.1177/09576509241292396
2024-10-17
Proceedings of the Institution of Mechanical Engineers Part A Journal of Power and Energy
Abstract:Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, Ahead of Print. In turbomachinery, manufacturing errors in blades have been found to impact aerodynamic performance. This paper aims to investigate the effect of manufacturing errors on the stability of compressor operation. To this end, a geometric uncertainty reduced-order model is developed to generate the normal profile error of rotor blades based on specific tolerances, considering the simultaneous variation of blade parameters during manufacturing. The stability margin improvement of the compressor is then calculated using computational fluid dynamics (CFD), and a neural network is employed to predict the relationship between the uncertainty input variables and the stability margin improvement. Finally, a large number of samples are generated using the Quasi-Monte Carlo method, and Sobol sensitivity analysis is performed. According to the results, manufacturing errors can reduce the stability margin by an average of 0.9% and up to 3% in the limiting case. The parameters that have the greatest impact on the stability of the compressor are the blade chord length of the hub section and the maximum thickness of the tip section. These two parameters affect blade tip blockage by influencing spanwise secondary flow on the suction surface. Additionally, the decrease in maximum thickness at the tip section affects the separation of the boundary layers on the suction surface, resulting in additional effects.
engineering, mechanical,thermodynamics