Abstract:This paper investigates the pull-in dynamics of single-sided and double-sided parallel-plate (SSPP and DSPP) structures employed in MEMS devices for acceleration measurement. A lumped electromechanical model considering a variable damping coefficient and external acceleration is developed for studying their pull-in dynamical behavior. The critical pull-in displacement and pull-in voltage for both parallel-plate structures operated with external acceleration are derived based on the static and dynamical analysis of the proposed model, which are in good agreement with the experimental results. The derived closed-form solutions are shown to be capable of predicting the pull-in behavior of both parallel-plate structures in an overdamped system. Two MEMS parallel-plate structures exhibit distinct pull-in characteristics due to their distinct configurations. The commonly used SSPP structure for MEMS devices is shown to have a relatively linear response to the external acceleration in terms of the critical pull-in displacement and pull-in voltage. However, the DSPP structure exhibits much larger yet nonlinear sensitivity of both the critical pull-in displacement and the critical pull-in voltage to a small range of external acceleration, which has the potential of developing high-sensitivity accelerometers whenever the sensitivity nonlinearity is compensated. Moreover, the effects of pressure are characterized for both DSPP and SSPP devices, which affects the difference between the critical static and dynamic pull-in voltages. The SSPP structure is shown to have the critical pull-in voltage proportional to the logarithmic magnitude of the pressure, while that of the DSPP structure do not vary linearly with respect to the logarithmic magnitude of the pressure.

Characterization and In-Situ Test of Mechanical Properties of MEMS-Based Inertial Delay Slider Mechanism

Multi-physics Analysis of an Electrostatically Actuated Microcantilever in Viscous Fluids

Investigation of a Complete Squeeze-Film Damping Model for MEMS Devices

Pull-In Dynamics of Two MEMS Parallel-Plate Structures for Acceleration Measurement

A Stiffness-Tunable MEMS Accelerometer

An New Instrument for Measuring Mechanical Compliance of Micro-Systems

On-chip testing method for measurements of friction and wear in moveable MEMS devices

An integrated push-to-pull micromechanical device: Design, fabrication, and in-situ experiment

An electrometric method to measure the mechanical parameters of MEMS devices

DETERMINATION OF MECHANICAL BEHAVIOR OF MEMS MATERIALS

Measurement of static and dynamic friction coefficients of sidewalls of bulk-microfabricated MEMS devices with an on-chip micro-tribotester

An on-chip micro-friction tester for tribology research of silicon based MEMS devices

Analysis, simulation and fabrication of MEMS springs for a micro-tensile system

Analysis and Optimization of a Compliant Mechanism-Based Digital Force/weight Sensor

Control of Micro Stick-Slip and Stiction in MEMS

A New Method to Measure Adhesion and Surface Forces Using A Closed-Loop Accelerometer

A measuring method for micro force based on MEMS planar torsional spring

Multifunctional In-Situ Testing Device for Investigating the Service Performance of Materials

Research on Multiphysics-Driven MEMS Safety and Arming Devices

Design and Testing of a Novel Nested, Compliant, Constant-Force Mechanism with Millimeter-Scale Strokes

Experimental Study of Tribological Performance on Silicon Micro-textured Surface