Abstract:One of the key objectives in the structural design of aircraft and spacecraft is the capability of accurate shape morphing that can meet various operational and environmental requirements for enhanced performance of the flight vehicles. The key to realize such capability could be dependent on the research into the design methods for finding the optimum layout of actuators and the associated controlling parameters. An integrated design optimization method for morphing a thin plate was presented with the shape like an aircraft wing via a concurrent design of the layout for given number of macro fiber composite (MFC)actuators and their relevant controlling parameters without the consideration of the external loads. An integrated optimization model is developed with the goal of minimizing the deviation between a required shape and an actual one through optimizing actuator locations, angles, layer number, symmetry and control voltages subject to the constraints, such as the breakdown voltage of the MFC and the geometrical limit of MFC-actuators. In the numerical examples, considered are three desired shapes of a thin plate with the shape like an aircraft wing, namely, bending, twisting and bending-twisting shapes. A total of 81 uniformly distributed observation points are used to implement shape morphing via evaluating the standard deviation between a desired shape and an actuated one. The optimal standard deviations for the bending, twisting, and bending-twisting shapes are 9.977×10–5, 4.394×10–4 and 5.308×10–4, respectively, which indicate a good accuracy for these multi-parameter shape morphing. Test panels of idealized control surfaces were prepared and experimental setup was constructed. The test results show a good correlation between the desired shape and the actuated one by using the present MFC-layout and controlling parameters, which in turn validates the effectiveness and feasibility of the proposed method.

The Design and Aerodynamic Analysis of Intelligent Variable Camber Airfoils with MFC

MECHANICAL MODELLING OF A MULTI-LAYER PARALLEL PRE-COMPRESSED MFC BIMORPH MORPHING WING

Unsteady Flow Simulation of a Variable-Sweep Morphing Aircraft Coupled with Flight Control System

High Actuation Capability and Smooth-Deformation Piezo Morphing Wing Based on Multi-Layer Parallel Pre-Compressed MFC Bimorph

Design and Structural Analysis for a Camber-Morphing Wing with Deformable Truss

Analysis on the Aerodynamic Characteristics of Variable Camber Airfoils with Continuous Smooth Morphing Trailing Edge

Structural Analysis of Morphing Airfoils for Camber Adaptive Wing

Aeroelastic model and analysis of an active camber morphing wing

Aeroelastic Study for Folding Wing During the Morphing Process

Kinematics of a Morphing Wing with Variable Span and Sweep

Integrated Design Optimization of MFC-layout Form and Control Parameters for Morphing Structural Shapes

Asymmetric Temperature Load Method for Simulation Study of Wing Leading Edge in Flight Deicing with MFC

The Morphing Trailing-Edge Wing Optimization Design of the Civil Aircraft

A variable camber wing concept based on corrugated flexible composite skin

Design and experiment of concentrated flexibility-based variable camber morphing wing

Unsteady Aerodynamic Characteristics of a Morphing Wing

Numerical Study of a Supercritical Airfoil/wing with Variable-Camber Technology

Analysis and Optimization of a Camber Morphing Wing Model

Design and analysis of a variable-sweep morphing aircraft with outboard wing section large-scale shearing

Modeling and Nonlinear Aeroelastic Analysis of a Wing with Morphing Trailing Edge

Design of Compliant Mechanism-Based Variable Camber Morphing Wing with Nonlinear Large Deformation