Abstract:The application of morphing wing enables vehicles to show better aerodynamic performance in various flight conditions. This article proposes a modular bilateral triangular pyramid (BTP) unit-based morphing wing skeleton (MWS) mechanism that may achieve continuous variable span-wise bend, span-wise twist, and sweep. A lockable morphing (LM) unit with the BTP unit is designed. Based on the Denavit-Hartenberg coordinate method and motion influence coefficient method, the kinematics of MWS mechanism is conducted. The theoretical models of the kinematic characteristics of the MWS mechanism during the three morphing patterns are obtained. The kinematic simulation models of three morphing configurations of the MWS mechanism are performed. The driving speed ratio of the linear actuator of span-wise bend and twist is analyzed during the twisting phase, and the analysis shows that there be a speed ratio minimizes the coupling bend angle. By comparing the results between the theoretical and simulation models, the accuracies of kinematic theoretical models under different morphing configurations are verified. At last, this article conducted a two-way fluid-structure interaction (FSI) analysis of morphing wing to obtain the influence of aerodynamic load on the flexible skin and skeleton mechanism, as well as the influence of structural deformation on the aerodynamic characteristics. Results show that the initial and swept states have the greatest impact on the out of plane bearing capacity of the flexible skin. In addition, the out-of-plane bulging deformation located at the trailing edge of the flexible skin is beneficial for improving aerodynamic performance, while the protrusion located at the leading edge increases air resistance. These findings provide important theoretical basis for the application of the MWS mechanism.

Design of Compliant Mechanism-Based Variable Camber Morphing Wing with Nonlinear Large Deformation

Design and Experiment of Compliant Mechanisms-Based Morphing Wing

Design and Structural Analysis for a Camber-Morphing Wing with Deformable Truss

Design Of Morphing Wing Leading Edge With Compliant Mechanism

MECHANICAL MODELLING OF A MULTI-LAYER PARALLEL PRE-COMPRESSED MFC BIMORPH MORPHING WING

High Actuation Capability and Smooth-Deformation Piezo Morphing Wing Based on Multi-Layer Parallel Pre-Compressed MFC Bimorph

Design and experiment of concentrated flexibility-based variable camber morphing wing

Kinematics of a Morphing Wing with Variable Span and Sweep

Application Status and Future Prospect of Aircraft Morphing Wing

A New Architecture of Morphing Wing Based on Hyperelastic Materials and Metastructures with Tunable Stiffness

Research Progress and Key Techniques of Active Morphing Wing at Medium and Small Scales

Conceptual Design of Compliant Structures for Morphing Wingtips Using Single-Row Corrugated Panels

Design and Rigid-Flexible Dynamic Analysis of a Morphing Wing Eight-Bar Mechanism

Design and Experiment of a Seamless Morphing Trailing Edge

Design Optimization and Testing of a Morphing Leading-Edge with a Variable-Thickness Compliant Skin and a Closed-Chain Mechanism

Structure Design of Variable Camber Wing Trailing Edge Based on Multi-Block Rotating Mechanism

Wind Tunnel Tests of 3D-Printed Variable Camber Morphing Wing

Large Deflection Model and Optimal Design for a Morphing Wing Leading-Edge Skin

Design, kinematic and fluid-structure interaction analysis of a morphing wing

Design and Validation of the Trailing Edge of a Variable Camber Wing Based on a Two-Dimensional Airfoil

Design and Analysis of a Variable-span and Cambered Span Morphing Wing for UAV.