Abstract:The application of morphing wing enables vehicles to show better aerodynamic performance in various flight conditions. This article proposes a modular bilateral triangular pyramid (BTP) unit-based morphing wing skeleton (MWS) mechanism that may achieve continuous variable span-wise bend, span-wise twist, and sweep. A lockable morphing (LM) unit with the BTP unit is designed. Based on the Denavit-Hartenberg coordinate method and motion influence coefficient method, the kinematics of MWS mechanism is conducted. The theoretical models of the kinematic characteristics of the MWS mechanism during the three morphing patterns are obtained. The kinematic simulation models of three morphing configurations of the MWS mechanism are performed. The driving speed ratio of the linear actuator of span-wise bend and twist is analyzed during the twisting phase, and the analysis shows that there be a speed ratio minimizes the coupling bend angle. By comparing the results between the theoretical and simulation models, the accuracies of kinematic theoretical models under different morphing configurations are verified. At last, this article conducted a two-way fluid-structure interaction (FSI) analysis of morphing wing to obtain the influence of aerodynamic load on the flexible skin and skeleton mechanism, as well as the influence of structural deformation on the aerodynamic characteristics. Results show that the initial and swept states have the greatest impact on the out of plane bearing capacity of the flexible skin. In addition, the out-of-plane bulging deformation located at the trailing edge of the flexible skin is beneficial for improving aerodynamic performance, while the protrusion located at the leading edge increases air resistance. These findings provide important theoretical basis for the application of the MWS mechanism.

Effect of spanwise distributed camber morphing on dynamic stall characteristics of a finite-span wing

Unsteady Flow Simulation of a Variable-Sweep Morphing Aircraft Coupled with Flight Control System

Aeroelastic model and analysis of an active camber morphing wing

MECHANICAL MODELLING OF A MULTI-LAYER PARALLEL PRE-COMPRESSED MFC BIMORPH MORPHING WING

Influence of Relative Thickness on Static and Dynamic Stall Characteristics and Prediction of Airfoils

Numerical Evaluations Of The Effect Of Leading-Edge Protuberances On The Static And Dynamic Stall Characteristics Of An Airfoil

Wake of a Bio-Inspired Flapping Wing with Morphing Wingspan

Design, kinematic and fluid-structure interaction analysis of a morphing wing

Effect of wingtip bending morphing on gust-induced aerodynamics based on fluid-structure interaction method

Numerical study of free stream turbulence effects on dynamic stall of pitching tubercled wings

On the Aeroelasticity of a Cantilever Wing Equipped with the Spanwise Morphing Trailing Edge Concept

Numerical simulation and dynamic mode decomposition analysis of the flow past wings with spanwise waviness

Mechanism Analysis of Hysteretic Aerodynamic Characteristics on Variable-Sweep Wings

Aerodynamic characteristics of a pitching airfoil with leading-edge morphing

Unsteady Lifting-Line Theory for Camber Morphing Wings State-Space Aeroelastic Modeling

The Effect of Torsional and Bending Stiffness on the Aerodynamic Performance of Flapping Wing

Effect of Trailing Edge and Span Morphing on the Performance of an Optimized NACA6409 Wing in Ground Effect

Design of Compliant Mechanism-Based Variable Camber Morphing Wing with Nonlinear Large Deformation

Laminar post-stall wakes of tapered swept wings

Parametric study on the dynamic aeroelastic analysis of a two-stage axially deploying telescopic wing

Unsteady aerodynamic characteristics of a morphing tail configuration