Abstract:Abstract Previous studies of test coils have demonstrated the high thermal and electrical stability of no-insulation (NI) high temperature superconducting (HTS) coils thanks to the presence of turn-to-turn current paths. These turn-to-turn current paths in a NI coil are significantly influenced by the contact resistivity. In practice, it is very challenging to measure the contact resistivity of a NI coil by direct experiments of short samples, since the contact resistivity of superconducting tapes is influenced by surface roughness and tolerance, stress, temperature etc. A proper simulation model is needed to investigate the contact resistivity of the NI coils with dedicated experiments. Hence, in this paper a distributed circuit model is employed. This model, implemented in Matlab 2018a, considers the local contact resistivity, self and mutual inductance, and HTS resistance, which depends on the supplied current, magnetic field and temperature. To validate the model, experimental results from literature, including sudden discharge, and charge–discharge processes, are employed and the results from simulations are consistent with experimental results. Then the model is used to investigate the equivalent contact resistivity of a 157-turn NI coil. Through the comparison of simulated and experimental results, it is found that the contact resistivity of the NI coil has an inhomogeneous distribution. When the current changes with different speeds, ramping rates or frequency, a different number of turn-to-turn contacts carries radial current. Since the turn-to-turn contacts have different contact resistivity, the equivalent contact resistivity calculated from sudden discharge cannot be used in simulations to reproduce all the experimental data.

The Electrical Behavior of Stacked Coated Conductors Concerning the Interlayer Resistance

Numerical Study on Simplified Resistive Joints of Coated Conductors: is There a Lower Limit of the Joint Resistance?

Electrical Contact Resistance in REBCO Stacks and Cables With Modified Surfaces

An Equivalent Homogenized Model for Non-Superconducting Joints Made by ReBCO Coated Conductors

Stress transfer mechanism and shear strength of multilayer composite superconducting tape

Current Characteristics of Stacked HTS Conductors With Gap Optimization: Experiment and Modeling

Numerical Study on Silver Diffusion Joints of Coated Conductors by Finite-Element Method

The current unbalance in stacked REBCO tapes -- simulations based on a circuit grid model

Effect of the Cu Stabilisation Layer on the Turn-to-turn Contact Resistance of a Non-Insulated REBCO Winding

Interfilament Resistance at 77 K in Striated HTS Coated Conductors

Calculation of AC losses in stacks and coils made of second generation high temperature superconducting tapes for large scale applications

Finite Element Models for Magnetic Shields Made of Stacked Superconducting Tape Annuli

Numerical Analysis on the Current Distribution and the Loss in HTS Stacked Tapes Considering Termination Resistances

3-D Numerical Simulations of Twisted Stacked Tape Cables

An efficient 3D finite element method model based on the T–A formulation for superconducting coated conductors

Superconducting properties and intergranular coupling of high-strength Sr1-xKxFe2As2/Ag/Nb/Cu composite conductors

Modeling of contact resistivity and simplification of 3D homogenization strategy for the H formulation

Study of contact resistivity of a no-insulation superconducting coil

Conductive Buffer Layers and Overlayers for the Thermal Stability of Coated Conductors

Effect of the SS304 Coating Layer on the Electrical and Thermal Properties of REBCO Commercial Tape