Abstract:Composite contacts used for dc relays can help reduce their cost and the amount of precious metals used in their construction. Because of their electrical properties, silver metal oxide-copper (AgMeO-Cu) composite contacts are widely used; however, at heavy loads, the bonding strength of the composite contact will change due to the influence of uneven temperature and stress distributions, which may even cause failure in the form of oxide layer peeling. Here, typical AgSnO2In2O3-Cu composite contacts are studied. A 3-D finite-element simulation model that considers contact making, arcing, and breaking was established to calculate the contact temperature and thermal stress after any operation cycle. The model can be used to determine the variation of the contact temperature and thermal stress distributions versus operation time during an electrical life cycle test. For different AgMeO layer thicknesses (0.25 and 0.38 mm), the temperature and thermal stress distribution of composite contact's bonding area were calculated under different current load levels: 30, 45, and 60 A, while the load voltage is a constant 17 V. Results show that the thickness of the AgMeO layer has a significant effect on the temperature and stress distribution of the bonding area in the moveable contact and the composite contacts may more easily curl and crack with an increment of the AgMeO layer thickness under the same current condition. The simulation results agree well with the experimental data and the relative error is less than 10%. The validity of the model and method was verified. The numerical model in the paper may be used to analyze a composite contact's properties and is therefore useful for design optimization and the selection of composite contact materials.

Numerical Study on Silver Diffusion Joints of Coated Conductors by Finite-Element Method

Numerical Study on Simplified Resistive Joints of Coated Conductors: is There a Lower Limit of the Joint Resistance?

An Equivalent Homogenized Model for Non-Superconducting Joints Made by ReBCO Coated Conductors

A Finite Difference Method for Determining Interdiffusivity of Aluminide Coating Formed on Superalloy

Three-dimensional simulation of single-lap and bridge joints of coated conductor under tension and bending tests

Numerical Study on Mechanical Behavior and Electromechanical Properties of Solder-Jointed REBCO-Coated Conductors

Relationships between mechanical strength and electrical conductivity for Cu–Ag filamentary microcomposites

Fabrication and Performance of Nb3Sn Superconducting Joints

Development of Electromagnetic Forming Nbti Superconducting Joint

Fabrication of Nbti Superconducting Joint by Electromagnetic Forming Method

Fabrication of non-superconducting and superconducting joints of Ag/Bi-2223 tapes by diffusion bonding

Numerical Simulation on Microdofect Evaluation of Diffusion Bonded Joints by Resistance Approach

Development of a persistent superconducting joint between Bi-2212/Ag-alloy multifilamentary round wires

Simulation and Experimental Study of Thermal Effects on Composite Contacts in Electrical Life Cycle Tests of DC Relays

Numerical Analyses of Electrical Contact Characteristics of YBCO Bulk with Silver Deposition

Improvement of the Solderability of Aluminum Alloy, Nickel, Stainless Steel and Copper by Metallization of Silver and Nickel for Power Semiconductors

Numerical Simulation of NbTi Superconducting Joint with Cold-Pressing Welding Technology

Coexistent Improvement of Thermal and Mechanical Performance at Si/Cu Joint by Thickness-Controlled Sn-Ag Bond Layer

Numerical calculations of high temperature superconductors with the J-A formulation

Multi-scale simulations of the mechanical behaviors of the W-Cu joint interface with a diffusion layer

Solid state Si diffusion and joint formation involving aluminum brazing sheet