Abstract:The effects of Mn loadings and precursors, catalyst preparation methods, incineration durations and temperatures, and the addition of Co and Ce on NO-reduction efficiency and selectivity (N2O formation) during the preparation of MnOx/Ti-based catalysts were studied by micropore-size analysis (XRD, XPS, SEM, and FTIR), while considering changeable parameters. Meanwhile, the performance of low-temperature SCR of NO with NH3 over the designed catalysts was tested under various gas hourly space velocities (GHSVs), NH3/NO molar ratios, and contents of NO, NH3, O-2, H2O, and SO2 in a lab-scale reactor. Overall, the Mn(0.3)Ce(0.1)/Ti catalyst, which had high NO-reduction efficiency and selectivity (low N2O formation), was recommended, with the following preparation methods: ultrasonic impregnation; manganese acetate precursor; and incineration at 500 degrees C. Appropriate textural properties (high surface area and small pore and crystallite sizes), well-dispersed amorphous manganese (rather than crystalline) on the anatase surface (rather than rutile), abundant active sites, and long residence time are essential for high NO-reduction efficiency. In practice, NO-reduction efficiency decreased with increasing GHSV and the NH3 and NO contents; however, it initially increased and then became saturated with an increasing NH3/NO molar ratio and O-2 content. Water deactivated the catalyst to a recoverable state, whereas SO2 resulted in unrecoverable deactivation.

Structure–performance relationships of MnO<sub>2</sub> nanocatalyst for the low-temperature SCR removal of NO<sub>X</sub> under ammonia

Structure–performance relationships of MnO2 nanocatalyst for the low-temperature SCR removal of NOX under ammonia

Morphological Effects of Manganese Dioxide on Catalytic Reactions for Low-Temperature Nh3-Scr

Structural and Surface Effect of MnO2 for Low Temperature Selective Catalytic Reduction of NO with NH3

Effects of Mno2 Crystal Structure and Surface Property on the Nh3-Scr Reaction at Low Temperature

Performance of Low-temperature SCR of NO with NH3 over MnOx/Ti-based catalysts

Structural properties of MnOx/Al-SBA-15 in low-temperature selective catalytic reduction of NOx with NH3

Manganese Oxide Nanorod Catalysts for Low-Temperature Selective Catalytic Reduction of NO with NH3

Structure and activity relationships of AMn2O4 (A = Mg and Zn) spinels in selective catalytic reduction of NOx with NH3

Structures and Catalytic Performances of Me/SAPO-34(Me=Mn,Ni,Co) Catalysts for Low-Tem Perature SCR of NO X by Ammonia

Ni-Mn Bi-Metal Oxide Catalysts for the Low Temperature SCR Removal of NO with NH3

Insights into the structure-activity relationships of highly efficient CoMn oxides for the low temperature NH<sub>3</sub>-SCR of NO<sub>x</sub>

Catalytic Reduction of NOx with NH3 over Different-Shaped MnO2 at Low Temperature

Low-temperature SCR of NOx by NH3 over MnOx/SAPO-34 prepared by two different methods: a comparative study

Novel Mnox-Ceo2 Nanosphere Catalyst for Low-Temperature Nh3-Scr

Structures and catalytic performances of Me/SAPO-34 (Me = Mn, Ni, Co) catalysts for low-tem perature SCR of NO by ammonia

2D, 3D Mesostructured Silicas Templated Mesoporous Manganese Dioxide for Selective Catalytic Reduction of NOx with NH3.

Novel Homogeneous and Mesoporous MnOx-Doped Ceria Nanosheets As Catalysts for Low-Temperature Selective Catalytic Reduction

Optimization of the performance of MnOx/MWCNTs catalyst by NH3 plasma for low temperature SCR

CeO2 Nanoparticle-Loaded MnO2 Nanoflowers for Selective Catalytic Reduction of NOx with NH3 at Low Temperatures

Catalytic Performance and in Situ Surface Chemistry of Pure Α-Mno2 Nanorods in Selective Reduction of NO and N2O with CO