Abstract:Friction is a primary failure mode in micro-nano electromechanical systems due to the high surface-to-volume ratio. Microgravity further complicates this issue in journal-bearing-like conformal contacts by promoting irregular disturbances. This paper aims to gain insights into the anti-friction design of journal-bearing-like devices through molecular dynamics simulation. A molecular dynamics model was proposed and the calculation method of the friction force was derived. In the absence of disturbance, the proposed model was compared with a non-conformal model which unfolded the bearing as a plane, and the influence of initial radial clearance and axis inclination on the friction force was investigated. The results showed that the proposed model could present more accurate friction forces than the non-conformal model. The friction force was inversely proportional to the initial clearance, and the axis inclination could reduce the friction force. Regarding disturbances as the superposition of two vibrations perpendicular to each other, in which case the trajectory of the journal was a Lissajous curve, the effects of frequency, stiffness coefficient, amplitude ratio, and frequency ratio were investigated. The results showed that the average friction force increased with the rising frequency in the range of 0.8 ~ 4.8 GHz, then decreased with the further increase of frequency. The average friction force was lowered when the stiffness coefficient increased from 100N/m to 1000N/m. For two representative frequencies, the average friction force exhibited different trends with the amplitude ratio. Except for the case of 1.25, increasing the frequency ratio could reduce the friction force. It seemed that applying a well-designed Lissajous route was a promising way to reduce friction.

Friction and Wear Properties of Microstructures in MEMS

Friction And Wear Properties Of Microstructures In Mems

Friction and wear properties in MEMS

Progress of Wear Properties on Micro-Electro-Mechanical Systems

New advances on the micro friction and wear

A Friction Force Microscopy Study on the Surface of Au Film, Cd-Disk and Lb Film

Friction and Wear Study of the Hemispherical Rotor Bushing in a Variable Capacitance Micromotor

MATERIALS WEAR AND WEAR IN MICRO-ELECTRO-MECHANICAL SYSTEMS

Characterisation Of Tribological Behaviour Of Silicon And Ceramic Coatings Under Repeated Sliding At Micro-Scale

An on-chip micro-friction tester for tribology research of silicon based MEMS devices

Progress of Micro-tribology on Micro-electro-mechanical Sy Stems

Experimental Study of Tribological Performance on Silicon Micro-textured Surface

Effect of Surface Energy on the Wear Process of Bulk-Fabricated Mems Devices

The Contact Behavior Analysis Between Microcomponents on a Low-Frequency Reciprocating-Fretting Ball-on-Flat Tribometer

Molecular Dynamics Simulation on Friction Properties of Textured Surfaces in Nanoscale Rolling Contacts

Dry Friction and Wear Properties of Several Hard Coating Combinations

Friction Properties of Journal-bearing-like Conformal Contacts in Microgravity Environment

Tribological Behaviors in Microforming Considering Microscopically Trapped Lubricant at Contact Interface

Effects of Interfacial Contact States on Tribological Behaviour in Micro-Sheet Forming

The microtribology and self-lubrication microsystems

Investigation on microtribological behavior of thin films using friction force microscopy