Abstract:<p>Machining of metal matrix composites (MMCs) is always challenging due to the mismatch of mechanical and thermal properties between the soft matrix and the abrasive reinforced particles, which causes rapid tool wear and severe surface damage. This paper investigates the effects of cutting regimes on surface integrity in machining of MMCs to understand the (sub) surface damage mechanism induced by thermo-mechanical loads in accordance with the evaluation on particle behaviours and matrix metallurgical transformation. For the first time, it is observed that two different cutting regimes (semi-brittle and ductile cutting) occur in machining of MMCs depending on the feed rate/uncut chip thickness. The machined surface morphology greatly depends on these two cutting regimes wherein various particle removal modes (i.e. push-in, crack and pullout) are generated due to the different cutting mechanisms. The semi-brittle cutting regime tends to happen under low uncut chip thickness and lead to obvious damaged surface morphology (high density of fractured particles), while matrix plastic deformation associated with high cutting temperature and built-up heat is found on the machined surface. Furthermore, the semi-brittle cutting regime further leads to an interesting phenomenon within the superficial surface: (i) a layer of broken SiC particles and (ii) the plastic flow of matrix around the hard particles which act as local barriers. Also, the aggregation of fractured particles and strain hardening of matrix can cause an increased hardness at the near-surface area. An additional cutting experiment on matrix material as a comparison revealed that the brittle fracture of reinforced particles plays a key role in the specific mechanism of MMCs under very low uncut chip thickness, which can cause cutting force increase, flank wear accelerate and the formation of surface damage.</p>

Micromechanics of machining and wear in hard and brittle materials

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

Molecular Dynamics Simulation of Micro Cutting Process of Abrasive Wear

Micromechanical Simulation of Fracture Behavior of Nanostructured Metals with Bimodal Grain Size Distribution

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Threshold damage mechanisms in brittle solids and their impact on advanced technologies

Damage Micromechanics for Constitutive Relations and Failure of Microcracked Quasi-Brittle Materials

On understanding the specific cutting mechanisms governing the workpiece surface integrity in metal matrix composites machining

Micromechanical Modeling of Strain-Softening in Microcrack-Weakened Quasi-Brittle Materials

Molecular Dynamics Analysis Micro-Mechanism Of Ductile Machining Single Crystal Silicon By Means Of Nanometric Cutting Technology

Fracture, my friend: the cutting of gummy metals

Mechanistic Studies in Friction and Wear of Bulk Materials

Exploring Ductility in Dental Ceramics

Wear behavior and damage characterization for AISI 52100 bearing steels: Effect of hardness and spherical carbides

Micromechanics-based model study of shear properties of brittle rocks

The Extreme Mechanics of Micro- and Nanoarchitected Materials

A story of two transitions: From adhesive to abrasive wear and from ductile to brittle regime

A new micromechanical damage model for quasi-brittle geomaterials with non-associated and state-dependent friction law

Effect of abrasive particle size and the influence of microstructure on the wear mechanisms in wear-resistant materials

Finite Element Model of Erosive Wear on Ductile and Brittle Materials

Advances in machining of hard tissues – From material removal mechanisms to tooling solutions