Abstract:Zn1-xNixFe2O4 ferrites up to x = 1.0 with Delta x = 0.2 have been synthesized via solid state reactions and the sol-gel autocombustion technique with step-by-step co-firing. Data on the chemical composition and the surface morphology of the samples have been obtained using a scanning electron microscope. An X-ray powder diffractometer has been used to establish the phase purity and to determine the unit cell parameters. It has been found that the obtained samples had a spinel structure with the Fd3m (No. 227) space group. The unit cell parameters decrease with increasing nickel concentration. The a unit cell parameter decreases almost linearly from similar to 8.443 angstrom for x = 0.0 down to similar to 8.337 angstrom for x = 1.0. The V unit cell volume decreases almost linearly from similar to 601.72 angstrom(3) for x = 0.0 down to similar to 579.52 angstrom(3) for x = 1.0. The magnetic characteristics of the obtained samples are determined and discussed. The Curie point of obtained samples varies in the range of 803.5-572.7 K. The maximum spontaneous magnetization of similar to 74.6 emu g(-1) at room temperature was fixed for the solid solution with x = 0.6. Ac-resistivity drops by more than 3 orders of magnitude in the frequency range 1-10(6) Hz. The composition with x = 0.6 has the minimum ac-resistivity of 5.3 kOm cm at a frequency of 10(6) Hz. The maximum value of the (mu ') real part of similar to 11.2 and (mu '') imaginary part of similar to 5.2 of the permeability in the frequency range of 50 MHz-10 GHz is observed for the composition with x = 0.4. The composite samples for the microwave study were prepared by mixing of the ferrite powders with molten paraffin wax. The volume fraction of the ferrite filler in the composites was 25%. The largest value of the (mu ') real part of similar to 3 and (mu '') imaginary part of similar to 0.63 of permeability is found for the x = 0.4 composite. The formation of the composite significantly reduces permeability.

Ferrite Plating of Fe3-xMxO4 (m=ni and Zn) Films Utilizing Alternate Electric Current

Soft Magnetic Properties of (Ni80fe20)(1-X)(ni0.5zn0.5fe2o4)(x) Films for High Frequency Applications

Magnetic And Electric Properties Of Fe3o4 Thin Films Sputtered On Metallic Underlayer

Structural and Magnetic Properties of NiZn–ferrite Thin Films Prepared by Radio Frequency Magnetron Sputtering

Ferrite Films Containing Mn, Ni and Ba Synthesized from Chelated Aqueous Solution at High Ph(=11-13)

Influence of Substrate Type on the Property of Nickle–zinc Ferrite Thin Films

Microstructure and Magnetic Properties of NiZn Ferrite Thin Films Prepared by Sol-Gel Method

Growth, magnetic, and electronic properties of Ni-Zn ferrites thin films

Spin-Spray Deposited Nizn-Ferrite Films Exhibiting Mu R ' > 50 at Ghz Range

MnZn Ferrite Films Deposited by RF Magnetron Sputtering with Low Substrate Temperature

NiCuZn Ferrite Thin Films Grown by a Sol–gel Method and Rapid Thermal Annealing

Influence of Film Thickness on the Properties of Ni-Zn Ferrite Thin Films

Magnetic and Structural Properties of NiZn Targets and Thin Film

Temperature-dependence of Magnetron Sputtered NiFe Films: Structure, Morphology, Optical, Electrical and OER Catalytic Properties

Effect of Zn addition on electrophysical properties of nickel ferrite thin films

Influence of preparation method on structural, optical and magnetic properties of synthesized Zn0.5Mg0.5-xNixFe2O4 nano-ferrite

Magnetization Switching Dynamics of Electrodeposited Fe–Ni Thin Films

Ni substitution effect on the structure, magnetization, resistivity and permeability of zinc ferrites

Investigation on Nickel Concentration Dependence Structural, Dielectric and Magnetic Properties of Ni–Zn Ferrites

Effect of Oxidant Concentration on Properties of Ferrite Films by Spin-Spray Deposition

Influence of Zinc Concentration on Structure, Complex Permittivity and Permeability of Ni–Zn Ferrites at High Frequency