Abstract:Hexagonal ferrites of M -type (in particular, BaFe 12 O 19 ) are magnetic materials with functional characteristics affected both by chemical composition and technology of their synthesis. We present the results of studying the magnetic and structural properties of BaFe 12 – x Cu x O 19 hexaferrites ( x = 0, 0.1, 0.2, 0.3, 0.4) obtained by hydrothermal synthesis with partial substitution of copper for iron. The composition of the synthesized samples was analyzed using X-ray diffraction, and the magnetic characteristics were measured using a vibration magnetometer. It has been revealed that the coercivity of the ferrite powders depends non-monotonically on the copper concentration and reaches the maximum (5629 Oe) and minimum (4698 Oe) values at x = 0 and x = 0.2. The presence of copper reduces the coercive force, but at the same time the values remain rather high compared to the results of similar studies. The saturation magnetization of the obtained ferrites gradually decreases (from 65.88 to 60.75 A · m 2 /kg at x = 0 and x = 0.4, respectively) with increasing. The distribution of Cu over ferrite sublattices was studied using Mössbauer spectroscopy. It is shown that in the hexaferrite structure, copper ions preferentially occupy 12 k and 4 f 1 sites. Hence, a decrease in the saturation magnetization with increasing x is most likely attributed to the presence of side non-magnetic phases observed on X-ray diffraction patterns. It is also revealed that during synthesis, copper participates in the formation of low-melting phases on the surface of hexaferrite grains which promotes agglomeration of the particles. Thus, the resulting powders can potentially be sintered at lower temperatures and, therefore, without a significant increase in the size of crystallites. Herewith, the coercivity retains its original high values. The results obtained can be used in developing ferrite permanent magnets with improved characteristics.

Ferrite Films Containing Mn, Ni and Ba Synthesized from Chelated Aqueous Solution at High Ph(=11-13)

Ferrite Plating of Ba-Containing Iron-Oxide Films Using Chelated Highly Alkaline (ph 11-13) Aqueous-Solutions

Ferrite Plating of Fe3-xMxO4 (m=ni and Zn) Films Utilizing Alternate Electric Current

Fabrication of Amorphous Fe-B Alloy Films by Contact Plating Method and Their Magnetic Properties

Solvent-free synthesis of hexagonal barium ferrite (BaFe 12 O 19 ) particles

Synthesis of Nanocrystalline Ferrites Zn0.4ni0.6cr0.5laxfe1.5-Xo4 and Its Magnetic Properties

The Multiferroic Properties of (bi(0.9)ba(0.1))(fe(0.95)mn(0.05))o(3) Films

X-ray spectroscopic study of BaFeO$_{3}$ thin films; an Fe$ ^{4+}$ ferromagnetic insulator

Study of the magnetic and structural properties of BaFe12 – xCuxO19 ferrites obtained by hydrothermal synthesis

Self-Assembled Batio3-Mnznfe2o4 Nanocomposite Films

Ferroic Metal-Oxide Films Grown by Polymer Assisted Deposition

Enhanced Ferromagnetism in BaNiF4 Film

Structural, Optical, And Electrical Properties Of (Mn1.56co0.96ni0.48o4)(1-X)(Lamno3)(X) Composite Thin Films

Structure, Magnetic and Microwave Properties of Indium-Doped Barium Ferrite Thick Films Prepared by Tape Casting

Synthesis and Magnetic Properties of Bafe12o19 Hexaferrite Nanoparticles by A Reverse Microemulsion Technique

Magnetic Properties of Barium Ferrite Prepared by Hydrothermal Synthesis

MnZn Ferrite Films Deposited by RF Magnetron Sputtering with Low Substrate Temperature

Synthesis and Study of Manganese-Substituted Barium Hexaferrite BaFe12–xMnxO19

Synthesis of Ferrite from Marine Manganese Nodules

Synthesis of Iron-Doped Manganese Oxides with an Ion-Sieve Property: Lithium Adsorption from Bolivian Brine

Enhanced Saturation Magnetization and Microwave Absorption Magnetic Properties of Mn-Co-Zr Substituted BaM Ferrite