Abstract:The development of molten salt reactors (MSRs) is a collaborative effort among academia, government laboratories, and industry, with the aim of realizing the potential of clean nuclear energy. However, the corrosion of structural alloys presents a significant engineering challenge in this application. Addressing this issue requires investment not only in testing and characterizing candidate alloys, but also in developing a scientific framework to understand the fundamental mechanisms governing the corrosion of metallic materials in molten fluorides which can then guide alloy design [1]. In this work, the corrosion behavior of binary Ni-Cr alloys (5-20 wt.% Cr) in molten LiF-NaF-KF (or FLiNaK) salts between 550 o C and 750 o C was interrogated using electrochemical methods coupled with thermo-kinetic analysis. Electrochemical techniques, including linear sweep voltammetry, electrochemical impedance spectroscopy (EIS) and chronoamperometry, were utilized to elucidate the rate-limiting kinetic factors and to identify the dependence of corrosion morphology on applied potential. Additionally, Ni-Cr alloys were also immersed 99.9% pure FLiNaK salts with a known oxidizer concentration (e.g., 0.1-5 wt.% EuF 3 ) coupled with open-circuit potential measurement to provide a time-based description of morphological evolution in the case of a dynamically changing electrode potential. These results are corroborated by examination of the post-corrosion morphology using scanning electron microscopy (SEM), transmission electron microscopy (TEM), and electron backscatter diffraction (EBSD) techniques as well as salt composition analysis using inductively coupled plasma mass spectrometry (ICP-MS), X-ray diffraction (XRD) and in situ cyclic voltammetry. The systematic choice of potential revealed multiple potential regimes in which Ni-Cr alloys exhibit distinctly different corrosion morphologies. At intermediate potentials, a porous bicontinuous structure is formed by dealloying of the less noble element (Cr) and percolation into the Ni-rich alloy within grains and along grain boundaries. At other potentials, charge transfer control dissolution of both Cr and Ni leads to the formation of a crystallographic faceted structure. The morphological differences suggest the presence of multiple corrosion processes in Ni-Cr in FLiNaK controlled by either transport or interfacial reaction. These findings can be explained through electrochemical processes at the alloy-salt interface, as well as the roles of surface, grain boundary and bulk diffusion kinetics involving the alloying constituents. Furthermore, the effect of radiation damage on Ni20Cr alloys on these rate-limiting corrosion regimes will be investigated. Acknowledgment Research is primarily supported as part of the fundamental understanding of transport under reactor extremes (FUTURE), an Energy Frontier Research Center (EFRC) funded by the U.S. Department of Energy (DOE), Office of Science, Basic Energy Sciences (BES). [1] Chan, H.L., et al. Npj Materials Degradation 6(1), 46 (2022).

Accelerated formation of M 2 C carbides by proton irradiation inhibits molten salt corrosion in Ni-based alloy

High temperature in-situ synchrotron-based XRD study on the crystal structure evolution of C/C composite impregnated by FLiNaK molten salt

Effect of irradiation damage defects on the impurity containing molten salt corrosion behavior in GH3535 alloy

Proton Irradiation-Decelerated Intergranular Corrosion of Ni-Cr Alloys in Molten Salt

Formation of nano-sized M2C carbides in Si-free GH3535 alloy

Microstructure evolution and lead-bismuth eutectic corrosion behavior of 11Cr1Si ferritic/martensitic steel after proton irradiation

Corrosion Behavior of the GH3535 and C276 Alloys at the Liquid/Gas LiCl–KCl Salt Interface at 550 °C

Corrosion Behavior and Elements Interdiffusion Between a Ni Coating and GH3535 Alloy with and Without a CrN Barrier in Molten Fluoride Salts

Corrosion Behavior of Ni-Cr Alloys with Different Cr Contents in NaCl-KCl-MgCl2

The effect of thermal-induced phase transformation on the corrosion behavior of Inconel 625 alloy in NaCl-KCl-MgCl 2 molten salt

The corrosion behavior of CVD SiC coatings on SiCf/SiC composites in a simulated molten salt reactors environment

Formation and evolution behavior of M 6 C carbide in a Ni-W-Cr superalloy

Corrosion Behavior of Binary Ni-Cr Alloys in Molten FLiNaK Salts at Different Electrochemical Potentials

In-situ proton irradiation/lead-bismuth eutectic corrosion synergistic effect on corrosion behaviour of 11Cr1W1Si ferritic/martensitic steel

Effect of metallic ion products on the corrosion of GH3535 alloy in a eutectic (Li, Na, K) F melt

Evolution of MC carbides in Ni-Mo-Cr-Ti based alloy for applications in molten salt reactors

Metallic impurities induced corrosion of a Ni-26W-6Cr alloy in molten fluoride salts at 850 oC

First-Principles Investigation of Grain Boundary Effects on Fluorine-Induced Initial Corrosion of NiCr Alloys

The inhibition of the interaction between CVD SiC and GH3535 alloy in molten LiF-NaF-KF salt by the Li metal

The effect of interstitial carbon atoms on defect evolution in high entropy alloys under helium irradiation

Stress-assisted corrosion behaviour of Hastelloy N in FLiNaK molten salt environment