Abstract:To fulfill the demands of ceramic components with high strength, high toughness and high reliability in key projects, a novel oscillatory pressure sintering (OPS) method was proposed in this study. With this new method, zirconia ceramics with high relative density, fine grains, high fracture strength, and excellent reliability, were prepared. As a comparison, zirconia ceramics were sintered by pressure -less sintering (PS) method and hot pressing (HP) method at same temperature. SEM analysis shows that the oscillatory pressure inhibits the rapid grain growth of zirconia at high temperature. Statistic results indicate that the OPS zirconia presents fine grain size at 251 nm, while the average sizes of PS and HP zirconia are 451 and 298 nm, respectively. In addition, the oscillatory pressure induces plastic deformation of grains and sliding of grain boundaries, facilitating elimination of closed pores at grain boundaries. As a result, the relative density of OPS zirconia reaches approximately 99.7%. Due to the refinement of grains and the increase in relative density, the OPS zirconia presents an increase from 1003 MPa to 1572 MPa in flexural strength, and an increase from 13 to 32 in Weibull modulus. Furthermore, its resistance to low temperature degradation is also improved because of the microstructure evolution.

Ultrastrong Tough Zirconia Ceramics by Defects‐engineering

Activating Continuous Dislocation Pinning Enhanced Toughness of Nanocomposite Coating Through Specially Oriented Semicoherent Heterointerface Lattice Distortion

Improved Mechanical Properties of 3YSZ Ceramics Prepared by Pressure-less Sintering Assisted by Cold Sintering under Mild Conditions

Zirconia Ceramics Consolidated by Oscillatory Pressure Sintering and Subsequent Carburization

Preparation of Zirconia Ceramics with High Density and Fine Grains by Oscillatory Pressure Sintering

Properties of a Pressureless Sintered 2Y-TZP Material Combining High Strength and Toughness

Ultra-high Strength ZTA Ceramic Foams with Large Amounts of Intragranular Structures Resulting from Dual-Phase Sol

Fabrication and Mechanical Properties of ZrO2–Al2O3–SiC(w) Composites by Oscillatory Pressure Sintering

Microstructure and Mechanical Properties of Zirconia Ceramics Consolidated by a Novel Oscillatory Pressure Sintering

Defects control of silicon nitride ceramics by oscillatory pressure sintering and consequent hot isotropic pressing

Ultrahigh toughness polycrystalline ceramics without fading of strength

An Oscillatory Pressure Sintering of Zirconia Powder: Densification Trajectories and Mechanical Properties

Ultrahigh-Strength Porous Ceramic Composites via a Simple Directional Solidification Process

Stronger and Tougher Nanosized Dense Ceria-Doped Tetragonal Zirconia Polycrystals by Sinter-Hip

Dual-Phase Super-Strong and Elastic Ceramic

Synergistic strengthening and toughening of oscillatory pressure sintered WC-ZrO2-Al2O3 ceramics

Ultrafine‐grained WC‐based Ceramics Prepared Via Two‐step Oscillatory Pressure Sintering

Grain Size Refinement of Additive Manufactured Ce-TZP Ceramics by Coupled Two-Step Pre-Sintering and HIP

Extreme dislocation-mediated plasticity of yttria-stabilized zirconia

Preparation and stereolithography 3D printing of ultralight and ultrastrong ZrOC porous ceramics

An Oscillatory Pressure Sintering of Zirconia Powder: Rapid Densification with Limited Grain Growth