Abstract:Assorted morphologies of precipitates in fcc/bcc transformation systems have been reported, which often exhibit irrational characteristic. Various models have been developed to explain the habit plane (or the broad facet), but the overall morphologies of the precipitates are seldom explained quantitatively. In this work, the equilibrium cross-section of rod-shape austenite precipitates in duplex stainless steel is determined by atomistic simulation. The input orientation relationship (OR) between fcc and bcc phase is determined according to the O-line criterion (one of the interfaces contains a single set of dislocations), with the condition that the invariant line lies in close-packed plane pair of (1 (1) over bar(1) over bar)(f)|(10 (1) over bar)(b) and the Burgers vector of O-lines is [011](f|)/2|((1) over bar 11)(b)/2. The obtained OR is close to the K-S OR ((11 (1) over bar)(f)//(01 (1) over bar)(b), [101](f)//(111)(b)), with the deviation of 1.27 degrees from the parallelism in both planes and directions. Interfacial energy of interfaces in various orientations in the zone axis of the invariant line ([0.75 0.10 0.65](f)//[0.52 0.68 0.52](b)) has been calculated. To ensure the reliability of the calculated values, an initial atomic configuration free of interstitial and vacancy is constructed for each interface. The energies of the O-line interface, the interface normal to either Delta g(((1) over bar 11)) or Delta g((020)) are found to have similar values, each at a local minimum. Based on the calculated interfacial energies, the equilibrium cross-section morphology is determined by the Wulff construction. The result shows that the morphology exhibits a near rhombus cross-section, which agrees consistently with experiments. One of the major facets is the O-line interface, normal to ((0.66) over bar 0.12 0.74)(f)//((0.51) over bar (0.24) over bar 0.83)(b), in agreement with the observation. The other facet is normal to Delta g((020)) (((0.25) over bar (0.87) over bar 0.42)(f)//(0.45 (0.73) over bar 0.51)(b)) in the calculated result, while it is normal to Delta g(((1) over bar 11)) (((0.36) over bar (0.77) over bar 0.53)(f)//(0.31 (0.71) over bar 0.63)(b)) in experimental results, with about 10 degrees difference between them. The discrepancy between calculated and observed results is probably because the experiments have not reached the equilibrium state. The dislocation structures in these three interfaces are identified from the atomic simulation results by a newly developed method based on the singular value decomposition of the Nye tensor. It confirms that the O-line interface contains a single set of [011](f)/2 dislocations with spacing of 1.5 nm. The interface normal to either Delta g(((1) over bar 11)) or Delta g((020)) contains two sets of dislocations. The dislocation structure in the facet normal to Delta g((1) over bar 11)) is in good agreement with experimental observation of the non-O-line facet, including the local decomposition of dislocation core to (1 (1) over bar(1) over bar)(f) stacking faults.

Dislocation Network on the Curved End Face of Α Precipitates in a Ti-8 Wt.% Fe Alloy

Dislocation Structure of Non-Habit Plane of Α Precipitates in a Ti–7.26 Wt.% Cr Alloy

Inclination-governed Deformation of Dislocation-Type Grain Boundaries

Structures and Migrations of Interfaces Between Β Precipitates and Α′ Matrix in a Ti-2.6 Wt% Mo Alloy

Characterization of the Interfacial Structure of Coarse α Precipitates in a Metastable β-Ti Alloy Ti-5Al-5Mo-5V-3Cr

A TEM study of the habit plane structure of intragrainular proeutectoid α precipitates in a Ti–7.26 wt%Cr alloy

A study of crystallography of α precipitates in a Ti-8 wt% Fe alloy

Direct observations of collinear dislocation interaction in a Fe-17.4 Mn-1.50 Al-0.29 C (wt.%) austenitic steel under cyclic loading by in-situ electron channelling contrast imaging and cross-correlation electron backscatter diffraction

An Investigation on the Equilibrium Morphology and Interfacial Structures of Pricipitates in Duplex Stainless Steel by Atomistic Simulation

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

Orientation distribution and deviation behaviors of dislocation loops in a quenched Al-Cu alloy

In-situ TEM study of dislocation emission associated with austenite growth

Dislocation-mediated migration of the α/β interfaces in titanium

Atomistic Simulation of Interactions Between an Edge Dislocation and Cu Precipitates with Different Chemical Compositions in Α-Fe

Data-mining of in-situ TEM experiments: On the dynamics of dislocations in CoCrFeMnNi alloys

TEM and HREM study of the interphase interface structure of Ti3Ni4 precipitates and parent phase in an aged TiNi shape memory alloy

Near-coincidence-sites modeling of the edge facet dislocation structures of α precipitates in a Ti–7.26 wt.% Cr alloy

A Preliminary In-situ TEM Study of Martensite/Austenite Interface Migration in an Fe-20Ni-5.4Mn Alloy

A Study of Dislocation Transmission Through a Grain Boundary in Hcp Ti–6Al Using Micro-Cantilevers

Interaction of $\langle a \rangle$ prismatic screw dislocations with the $α-β$ interface side face in $α-β$ Ti alloys

Determination of the Structure of Α-Β Interfaces in Metastable Β-Ti Alloys