Abstract:To improve the linearity of direct conversion receivers (DCRs), two high-linearity methods for high second-order intercept points (IP2s) and high third-order intercept points (IP3s) are proposed. To improve IP3s, a transconductance equalization technique for a complementary input operational amplifier (OPAMP) is proposed in an active-RC low-pass filter (LPF), while a digital-analog hybrid DC offset calibration (DCOC) method is proposed to improve IP2s. For one thing, the proposed transconductance equalization technique employs a pair of resistors to guarantee high voltage gain for an OPAMP with two-stage Miller topology under a high-input voltage swing to improve linearity with little deterioration of the noise performance. For another, during the DCOC method, the low-noise amplifier is turned off and replaced by an equivalent resistance of the output impedance of the low-noise amplifier to ensure the accuracy and effectiveness of the DCOC method. Fabricated in 40-nm CMOS technology, the receiver with proposed methods can realize a noise figure of 2.6–3.5 dB in the full frequency band, with an OIP3 of 28 dBm, an IM2 more than 70 dBc, and a remaining DC of −53.2 dBm under the total voltage gain of 60 dB.

Design And Test Of A Low-Voltage Rail-To-Rail Op-Amp With Constant Transconductance And Sr

The Design of a Low-Voltage Rail-to-Rail CMOS Operational Amplifier

High-Speed Operational Amplifier Based on 0.5 Μm CMOS Process

High-speed and high-gain operational amplifier

A 3.6V Rail-to-Rail Operational Amplifier with Constant G M

Low-dropout regulator with no off-chip capacitor and ultra low power consumption

A Broadband Constant-Transconductance Rail-to-Rail CMOS Op-Amp for Low-Voltage VLSI Systems

Low Dropout Linear Regulator with No Off-Chip Capacitor and Low Power Consumption

Low power design for 14-bit 100MSPS pipelined ADC

1-V Low-Power Programmable Rail-to-Rail Operational Amplifier with Improved Transconductance Feedback Technique.

A High Bandwidth G(M)-Constant Rail-To-Rail Cmos Opamp for Low Voltage Vlsi Systems

High-Linearity Direct Conversion Receiver with the Transconductance Equalization Technique and DCOC Method

Design of Differential Variable-Gain Transimpedance Amplifier in 0.18 Μm SiGe BiCMOS

Compact 50-62 GHz Current-Reused Low-Noise Amplifier with Gate-Drain Transformer Feedback

A Low-Power CMOS Rail-to-Rail Input/Output Constant-Gm Operational Amplifier

Supply-adaptive Rail-to-rail CMOS OPAMP

A low power constant-Gm rail-to-rail operational transconductance amplifier by recycling current

A high current efficiency rail-to-rail operational amplifier

A high gain low offset amplifier with rail-to-rail inputs

A Low Power Current Recycling Constant-GM Rail-to-rail OTA