Abstract:In this paper a CMOS operational amplifier is presented which operates at 2V power supply and 1microA input bias current at 0.8 micron technology using non conventional mode of operation of MOS transistors and whose input is depended on bias current. The unique behaviour of the MOS transistors in subthreshold region not only allows a designer to work at low input bias current but also at low voltage. While operating the device at weak inversion results low power dissipation but dynamic range is degraded. Optimum balance between power dissipation and dynamic range results when the MOS transistors are operated at moderate inversion. Power is again minimised by the application of input dependant bias current using feedback loops in the input transistors of the differential pair with two current substractors. In comparison with the reported low power low voltage opamps at 0.8 micron technology, this opamp has very low standby power consumption with a high driving capability and operates at low voltage. The opamp is fairly small (0.0084 mm 2) and slew rate is more than other low power low voltage opamps reported at 0.8 um technology [1,2]. Vittoz at al [3] reported that slew rate can be improved by adaptive biasing technique and power dissipation can be reduced by operating the device in weak inversion. Though lower power dissipation is achieved the area required by the circuit is very large and speed is too small. So, operating the device in moderate inversion is a good solution. Also operating the device in subthreshold region not only allows lower power dissipation but also a lower voltage operation is achieved.

A Low-Power CMOS Rail-to-Rail Input/Output Constant-Gm Operational Amplifier

The Design of a Low-Voltage Rail-to-Rail CMOS Operational Amplifier

High-Speed Operational Amplifier Based on 0.5 Μm CMOS Process

A 3.6V Rail-to-Rail Operational Amplifier with Constant G M

High-speed and high-gain operational amplifier

1-V Low-Power Programmable Rail-to-Rail Operational Amplifier with Improved Transconductance Feedback Technique.

A low power constant-Gm rail-to-rail operational transconductance amplifier by recycling current

A Robust Rail-to-Rail CMOS Operational Amplifier

A 65 nm CMOS rail-to-rail auto-zero operational amplifier based on charge pump internal power supply

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

Design of Differential Variable-Gain Transimpedance Amplifier in 0.18 Μm SiGe BiCMOS

Compact 50-62 GHz Current-Reused Low-Noise Amplifier with Gate-Drain Transformer Feedback

A High Bandwidth G(M)-Constant Rail-To-Rail Cmos Opamp for Low Voltage Vlsi Systems

A Low Power Current Recycling Constant-GM Rail-to-rail OTA

A Novel Low-Voltage Operational Amplifier for Low-Power Pipelined ADCs

A Broadband Constant-Transconductance Rail-to-Rail CMOS Op-Amp for Low-Voltage VLSI Systems

A high current efficiency rail-to-rail operational amplifier

Design of A Low Power Low Voltage CMOS Opamp

A high gain low offset amplifier with rail-to-rail inputs

Design of Class AB Micropower Operational Amplifier with Rail-to-Rail Output