Abstract:This paper proposes a new single stage high current efficiency rail to rail amplifier (HCE-RTR). Due to the combination of a new constant transconductance control circuit and local common mode feedback (LCMFB) technique, the proposed rail to rail amplifier not only achieves improvements in unity-gain bandwidth (GBW) and slew rate (SR), but also ensures input stage transconductance constancy within the rail to rail voltage range. Based on the SMIC 180 nm process, the post-layout simulation results show that the proposed amplifier achieves rail-to-rail input/output. The simulated open loop AC response shows the DC gain, GBW, and PM are 66.2 dB, 8.2 MHz, and 60.97 o , respectively. When the driving load capacitance is 70 pF, the transient response simulation results show that the proposed amplifier achieves 0.039 μ s average 1% settling time, and about 5.73 V/ μ s average slew rate. Note that under the condition of 1.8 V power supply, the power consumption is only 122.4 μ W, proving the proposed amplifier can achieve high current efficiency while maintaining stability.

A Broadband Constant-Transconductance Rail-to-Rail CMOS Op-Amp for Low-Voltage VLSI Systems

A High Bandwidth G(M)-Constant Rail-To-Rail Cmos Opamp for Low Voltage Vlsi Systems

High-Speed Operational Amplifier Based on 0.5 Μm CMOS Process

The Design of a Low-Voltage Rail-to-Rail CMOS Operational Amplifier

High-speed and high-gain operational amplifier

An Analysis and Implementation of Common Mode Feedback in High-Speed Fully Differential Op-Amp

A 3.6V Rail-to-Rail Operational Amplifier with Constant G M

Design And Test Of A Low-Voltage Rail-To-Rail Op-Amp With Constant Transconductance And Sr

A Robust Rail-to-Rail CMOS Operational Amplifier

A 2.5 Gb/s CMOS Low Noise Transimpedance Amplifier with Active Feedback

A high gain low offset amplifier with rail-to-rail inputs

Broadband matching variable-gain low-noise amplifier

A Low-Power CMOS Rail-to-Rail Input/Output Constant-Gm Operational Amplifier

A novel accurate dB-linear control circuit topology for variable gain amplifiers in BiCMOS technology

Design of Differential Variable-Gain Transimpedance Amplifier in 0.18 Μm SiGe BiCMOS

A Three Stage, Fully Differential 128–157 GHz CMOS Amplifier with Wide Band Matching

1-V Low-Power Programmable Rail-to-Rail Operational Amplifier with Improved Transconductance Feedback Technique.

Supply-adaptive Rail-to-rail CMOS OPAMP

A high current efficiency rail-to-rail operational amplifier

Low-voltage Transconductor with Wide Input Range and Large Tuning Capability