Abstract:In this investigation, a new type of CaCl2 center dot 6H(2)O/expanded graphite(EG) form-stable composite phase change material (PCM), with suitable latent heat, high heat conductivity and small overcooling degree, was prepared. And this novel PCM based phase change module that store heat using electricity heating were designed and manufactured. The modules' heat storage and discharge capabilities were investigated using experimental study and numerical simulation. It is known through experiments that the stable heat radiation of the module can be stayed for a comparatively long time, which satisfies the heating need of the people in the room. A numerical model was developed and validated by experimental results, which was used for parametric optimization design of the modules. On the basis of the simulation analysis, the thermal performance reaches the best when the working conditions are such that the heat conductivity of PCM packed in the module is 3 similar to 5 W/(m center dot K), the electrical power is 9.00 - 9.85 W/m with the heating wire heating 8 h under the designed arrangement. Under the working condition of 9.85 W/m electrical power and 4 W/(m center dot K) heat conductivity, it would be better to keep the spacing of carbon fiber heating wire in the range of 40 mm to 45 mm, in order to pledge energy utilization efficiency and continuous heating. Moreover, corresponding adjustment measures are taken on the basis of the changes of local electrovalence policies. In general, the phase change module that store heat using electricity heating proposed in this paper exhibits good thermal performance. The research offers reference for the future parameterized development and utilization of such devices.

Numerical Study On Resistance Change Characteristics Of Phase Change Materials

Thermal conductivity measurement of phase-change material near melting point based on perturbation method

Study on nucleation characteristic of phase change memory set operation using numerical simulation

Numerical Simulation on Phase-Change Heat Transfer Within Microencapsulated Phase Change Material

Numerical Investigations of Heat Transfer in Phase Change Materials Using Non-Equilibrium Model

Investigation of the Effect of Thermal Resistance on the Performance of Phase Change Materials

Numerical Study on Thermal Characteristics of a Micro-Encapsulated Phase Change Composite Plate

Review of the Modeling Approaches of Phase Change Processes

Numerical investigations of melting process with sidewall heating under various control parameters

A Three-Dimensional Numerical Simulator of Phase-Change Memory by Random Nucleation and Growth Approach

Numerical simulation, ANN training and predictive analysis of phase change material with 3D printing lattice structures

Experimental and Numerical Investigation of the Thermal Performance of Phase-Change Module Using Built-in Electrical Heating

Influence of Physical Parameters of Phase-change Film on Thermal Control of Electronic Devices

Measuring Electrical Resistivity at the Nanoscale in Phase-Change Materials

Real‐time experimental study and numerical simulation of phase change material during the discharge stage: Thermo‐fluidic behavior, solidification morphology, and energy content

A Micromechanical Model for Phase-Change Composites

Investigation of Nano-Phase Change for Phase Change Random Access Memory

A novel model for calculating the melting process of composite phase change materials

Numerical simulation on the thermal performance enhancement of energy storage tank with phase change materials

Thermal performance evaluation of new energy vehicle pre-charge resistors based on phase change material cooling

Numerical Simulation On Melting And Solidification Of A Phase-Change Material In An Aluminum Plate-Fin Thermal Storage