Abstract:The paper describes physical and numerical simulations of a manufacturing process composed of hot forging and controlled cooling, which replace the conventional heat treatment technology. The objective was to investigate possibilities and limitations of the heat treatment with the use of the heat of forging. Three steels used to manufacture automotive parts were investigated. Experiments were composed of two sets of tests. The first were isothermal (TTT) and constant cooling rate (CCT) dilatometric tests, which supplied data for the identification of the numerical phase transformation model. The second was a physical simulation of the sequence forging-cooling on Gleeble 3800, which supplied data for the validation of the models. In the numerical part, a finite element (FE) thermal-mechanical code was combined with metallurgical models describing recrystallization and grain growth during forging and phase transformations during cooling. The FE model predicted distributions of the temperature and the austenite grain size in the forging, which were input data for further simulations of phase transformations during cooling. A modified JMAK equation was used to calculate the kinetics of transformation and volume fraction of microstructural constituents after cooling. Since the dilatometric tests were performed for various austenitization temperatures before cooling, it was possible to include austenite grain size as a variable in the model. An inverse algorithm developed by the authors was applied in the identification procedure. The model with optimal material parameters was used for simulations of hot forging and controlled cooling in one of the forging shops in Poland. Distributions of microstructural constituents in the forging after cooling were calculated. As a consequence, various cooling sequences during heat treatment could be analyzed and compared.

Thermal Simulation Model of Aero-Engine Blade Material Forging Simulation

Dependence of Microstructural Evolution on the Geometric Structure for Serviced DZ125 Turbine Blades

Three-Dimensional Finite Element Modelling of Forging of a Titanium Alloy Aerofoil Sectioned Blade

Influence of forging velocity on temperature and phases of forged Ti-6Al-4V turbine blade

Aero-Engine Blade Cryogenic Cooling Milling Deformation Simulation and Process Parameter Optimization

Physical and Numerical Simulations of Closed Die Hot Forging and Heat Treatment of Forged Parts

Rheology of Ti-6Al-4V alloy under non equilibrium conditions during β forging

Optimizing hot forging parameters for gas turbine blade formation: a comprehensive study

Microstructure and fatigue properties of TC4 titanium alloy treated by α+β forging process

Numerical simulation and experimental validation of microstructure evolution during the upsetting process of a large size martensitic stainless steel forging

A new process chain combining cross-wedge rolling and isothermal forging for the forming of titanium alloy turbine blades

SIMULATION ANALYSIS OF WHEEL BEARING FORGING PROCESS BASED ON DEFORM

Numerical simulation of microstructure evolution of flange axle during hot forging

Stress Analysis and Deformation Prediction of a Heavy Hydraulic Turbine Blade Casting During Casting and Heat Treatment

Numerical simulation and experiment study on hot extrusion process of 18Ni (250) maraging steel large fan shaft for aero-engines

An Enhanced Flow-Thermo-Structural Modeling and Validation for the Integrated Analysis of a Film Cooling Nozzle Guide Vane

NUMERICAL SIMULATION OF DYNAMIC DECRYSTALLIZATION DURING HOT FORGING

Dynamic Softening Mechanism on Steel of ASME SA508-3 During Hot Working

Microstructure simulation and experiment investigation of dynamic recrystallization for ultra high strength steel during hot forging

Finite element analysis of heavy forging processing with JTS method

Through Process Numerical Simulation of a Heavy Hydro Turbine Blade Casting