Abstract:This study introduces a multidisciplinary design methodology tailored for enhancing the performance of cooled turbine blades by amalgamating thermal and aerodynamic calculation modules. The approach is unique in terms of its integration of a multi-objective optimization platform, aimed at refining aerodynamic performance and gauging the heat transfer capabilities during the preliminary aerodynamic design phase. To accomplish this objective, a one-dimensional pipe-network calculation tool was incorporated into the thermal module to quickly evaluate the heat transfer performance of the blades under different conditions. This tool also provides more realistic film hole inlet boundary conditions essential for three-dimensional aerodynamic calculations. Implementing this platform in optimizing a high-pressure turbine blade revealed a Pareto-optimal front, comprising −η1 and η2 (representing optimization objectives for aerodynamic and heat transfer performance, respectively), showcasing a constrained relationship. Upon scrutinizing three optimization cases against the prototype, optimization case 1 demonstrates the most significant enhancements in aerodynamic performance, showing a 0.2015% improvement in aerodynamic efficiency relative to the prototype. Conversely, optimization case 3 displays a comparatively modest augmentation in aerodynamic performance but excels notably in heat transfer performance, showcasing a 7.61% reduction in the maximum temperature of the blade surface compared to the prototype. Through adept optimization strategies and meticulous variable selection, we maintained a relatively stable mainstream mass flow across the optimization cases (less than 0.05% variation). These findings underscore the efficacy of our multidisciplinary design approach for cooled turbine blades, promising efficiency improvements in current design practices and potential reductions in project duration.

Optimizing hot forging parameters for gas turbine blade formation: a comprehensive study

Three-Dimensional Finite Element Modelling of Forging of a Titanium Alloy Aerofoil Sectioned Blade

Design and optimization of turbine blade preform forging using RSM and NSGA II

Influence of forging velocity on temperature and phases of forged Ti-6Al-4V turbine blade

Optimization Design of Aspect Ratio and Solidity of a Heavy-Duty Gas Turbine Transonic Compressor Rotor

Simultaneous optimization of process parameters in hot forging of axisymmetric part of AA7075 by minimizing forming force and considering variation of stress distribution

A new process chain combining cross-wedge rolling and isothermal forging for the forming of titanium alloy turbine blades

Physical and Numerical Simulations of Closed Die Hot Forging and Heat Treatment of Forged Parts

Transpiration Cooling of High Pressure Turbine Vane with Optimized Porosity Distribution

Technical review on design optimization in forging

Influence of film cooling hole geometry on the gas turbine blade strength

Modeling research on FM forging process of heavy low-pressure turbine rotor

Numerical simulation and experiment study on hot extrusion process of 18Ni (250) maraging steel large fan shaft for aero-engines

Lifing Assessment of Gas Turbine Blade Root Affected by Out-of-Tolerances

CFD simulation and aerodynamic optimization of two-stage axial high-pressure turbine blades

Predictive Modeling and Optimization of Hot Forging Parameters for AISI 1045 Ball Joints Using Taguchi Methodology and Finite Element Analysis

A cooled turbine blade design and optimization method considering the cooling structure influence

Transformation characteristics of temperature and phases within Ti-6Al-4V aeroengine drum in hot forging and air cooling procedures

Analysis and design optimization of double-sided deep cold rolling process of a Ti-6Al-4V blade

Numerical simulation and experiment research on forming of hollow blade with 304 stainless steels and Ti–6Al–4V tubes by sand mandrel

Comprehensive assessment of the production of a pipe billet with a flange by forging at various temperature conditions