Abstract:Residual stresses (RS) in hot forging severely degrade the machining accuracy and stability of super alloy parts. This is the main reason for deformation during subsequent mechanical machining. RS need recognition, as well as the microstructure and properties achieved by forging. In this study, a simulation and experimental research on the single-pass compression of GH4169 are presented. RS variations with forging temperature, loading speed, and cooling speed are established by finite element (FE) simulation. Based on the FE results, an experiment is conducted at a temperature of 1020 °C, loading speed of 25 mm/s, and press amount of 16 mm, immediately followed by water cooling. A new layer-stripping method is put forward for the high-efficiency measurement and correction of interior RS. Compared with the traditional strain gauge layer-stripping method, the measurement efficiency of the new layer-stripping method is increased by 10 times. Meanwhile, grain photographs are collected and grain size evolution is summarized; thus, the RS is characterized and evaluated from the angle of grains. It is demonstrated that the RS level rises with the increase in forging temperature, loading speed, and cooling speed, while the cooling method influences both the stress value and distribution. Compressive RS changes to tensile, while the average grain size reduces from the surfaces to the center. In the compressive regions, stress values share the same rules as grain size, while, in the tensile regions, they are contrary. The RS levels are divided according to the grain degree standard. According to the residual stress and grain distribution law of the blank, the optimal position of the part in the blank can be determined. Compared with the center position of the part in the blank, the residual stress of the part is reduced by 70%. The results provide useful strategies for the better design of forging technology, qualification examinations, and subsequent mechanical machining.

Simultaneous optimization of process parameters in hot forging of axisymmetric part of AA7075 by minimizing forming force and considering variation of stress distribution

Predictive Modeling and Optimization of Hot Forging Parameters for AISI 1045 Ball Joints Using Taguchi Methodology and Finite Element Analysis

Multi-objective optimization of concave radial forging process parameters based on response surface methodology and genetic algorithm

Study on Hot Deformation Behavior and Bending Forging Process of 7075 Aluminum Alloy

Optimization of Forging Preforms by Using Pseudo Inverse Approach

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Optimization of hot deformation parameters for multi-directional forging of Ti65 alloy based on the integration of processing maps and finite element method

Optimization of multi-directional forging parameters of large-scale Mg-Gd-Y-Zn-Zr alloy forged part guided by finite element simulation

Optimizing hot forging parameters for gas turbine blade formation: a comprehensive study

Technical review on design optimization in forging

Multi-Objective Optimization of Process Parameters in 6016 Aluminum Alloy Hot Stamping Using Taguchi-Grey Relational Analysis

Extrusion of 7075 Aluminium Alloy Through Double-Pocket Dies to Manufacture a Complex Profile

Studies on friction behaviour of aluminium AA4032 alloy during forging using ring compression test

Influence of Forging Temperature on the Microstructures and Mechanical Properties of a Multi-Directionally Forged Al–Cu–Li Alloy

Microstructural evolutions and mechanical properties of 6082 aluminum alloy part produced by a solution-forging integrated process

Optimization of Processing Parameters of Aluminum Alloy Cylindrical Parts Based on Response Surface Method during Hydromechanical Deep Drawing

Physical and Numerical Simulations of Closed Die Hot Forging and Heat Treatment of Forged Parts

Research on High Temperature Stamping Forming Performance and Process Parameters Optimization of 7075 Aluminum Alloy

Selection of Optimal Hot Extrusion Process Parameters for AA6061-Fly Ash Composites: Using Simulation

Characterization of Residual Stresses and Grain Structure in Hot Forging of GH4169

Effect of Cold Pressing Deformation on Microstructure and Residual Stress of 7050 Aluminum Alloy Die Forgings