Abstract:This study employs the finite element (FE) method to analyze the Incremental Sheet Forming (ISF) process of Ti-6Al-4V titanium alloy. The numerical modeling of pressure-assisted warm forming of Ti-6Al-4V sheets with combined oil-heating and friction stir rotation-assisted heating of the workpiece is presented in this article. The thermo-mechanical FE-based numerical model took into account the characteristics of the mechanical properties of the sheet along with the temperature. The experimental conditions were replicated in FEM simulations conducted in Abaqus/Explicit, which incorporated boundary conditions and evaluated various mesh sizes for enhanced accuracy and efficiency. The simulation outcomes were compared with actual experimental results to validate the FE-based model's predictive capacity. The maximum temperature of the tool measured using infrared camera was approximately 326 °C. Different mesh sizes were considered. The results of FEM modeling were experimentally validated based on axial forming force and thickness distribution measured using the ARGUS optical measuring system for non-contact acquisition of deformations. The greatest agreement between FEM results and the experimental result of the axial component of forming force was obtained for finite elements with a size of 1 mm. The maximum values of the axial component of forming force determined experimentally and numerically differ by approximately 8%. The variations of the forming force components and thickness distribution predicted by FEM are in good agreement with experimental measurements. The numerical model overestimated the wall thickness with an error of approximately 5%. By focusing on the heating techniques applied to Ti-6Al-4V titanium alloy sheet, this comparative analysis underlines the adaptability and precision of numerical analysis applied in modeling advanced manufacturing processes.

Three-Dimensional Finite Element Modelling of Forging of a Titanium Alloy Aerofoil Sectioned Blade

Finite Element Simulation and Analysis of Aluminum Alloy Three-Dimensional Milling

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Optimizing hot forging parameters for gas turbine blade formation: a comprehensive study

A new process chain combining cross-wedge rolling and isothermal forging for the forming of titanium alloy turbine blades

Influence of forging velocity on temperature and phases of forged Ti-6Al-4V turbine blade

Microstructure and fatigue properties of TC4 titanium alloy treated by α+β forging process

Effect of Titanium Based Alloys on Thermo-Mechanical Behavior in 3D Forging Simulation

Numerical simulation and experiment study on hot extrusion process of 18Ni (250) maraging steel large fan shaft for aero-engines

Rheology of Ti-6Al-4V alloy under non equilibrium conditions during β forging

Advanced FEM Insights into Pressure-Assisted Warm Single-Point Incremental Forming of Ti-6Al-4V Titanium Alloy Sheet Metal

Numerical simulation and experiment research on forming of hollow blade with 304 stainless steels and Ti–6Al–4V tubes by sand mandrel

Physical and Numerical Simulations of Closed Die Hot Forging and Heat Treatment of Forged Parts

Casting Design Optimization Using Numerical Simulation of Precision Forging Die for Large Titanium Alloy Integral Bulkhead

High Nb–TiAl Intermetallic Blades Fabricated by Isothermal Die Forging Process at Low Temperature

Performance analysis of different friction models in the numerical simulation of the isothermal forging process

Comparative Analysis of Finite Element Formulations for Simulating Hot Forming of Ti-6Al-4V Aerospace Components