Abstract:Warm deformation is a plastic-forming process that differs from traditional cold and hot forming techniques. At the macro level, it can effectively reduce the problem of high deformation resistance in cold deformation and improve the surface decarburization issues during the hot deformation process. Microscopically, it has significant advantages in controlling product structure, refining grain size, and enhancing product mechanical properties. The Gleeble-1500D thermal-mechanical physical simulation system was used to conduct isothermal compression tests on GCr15 bearing steel. The tests were conducted at temperatures of 600-1050 °C and strain rates of 0.01-5 s-1. Based on the experimental data, the critical strain model and dynamic recrystallization model for the warm-hot forming of GCr15 bearing steel were established in this paper. The model accuracy is evaluated using statistical indicators such as the correlation coefficient (R). The dynamic recrystallization model exhibits high predictive accuracy, as indicated by an R-value of 0.986. The established dynamic recrystallization model for GCr15 bearing steel was integrated into the Forge® 3.2 numerical simulation software through secondary program development to simulate the compression process of GCr15 warm-hot forming. The dynamic recrystallization fraction was analyzed in various deformation regions. The grain size of the severe deformation zone, small deformation zone, and difficult deformation zone was compared based on simulated compression specimens under the conditions of 1050 °C and 0.1 s-1 with the corresponding grain size obtained with measurement based on metallographic photos; the relative error between the two is 5.75%. This verifies the accuracy of the established dynamic recrystallization and critical strain models for warm-hot deformation of GCr15 bearing steel. These models provide a theoretical basis for the finite element method analysis and microstructure control of the warm-hot forming process in bearing races.

NUMERICAL SIMULATION OF DYNAMIC DECRYSTALLIZATION DURING HOT FORGING

Modelling of Dynamic Recrystallization in Hot Working

Numerical simulation of microstructure evolution of flange axle during hot forging

Microstructure simulation and experiment investigation of dynamic recrystallization for ultra high strength steel during hot forging

Numerical Simulation of Recrystallization and Grain Growth Evolutions During Metal Forming Processes

Numerical Simulation and Experimental Verification of Microstructure Evolution in A 3-Dimensional Hot-Upsetting Process

Intelligent Modeling and Prediction of Elastic Modulus of Concrete Strength via Gene Expression Programming

Finite Element Analysis of Dynamic Recrystallization Model and Microstructural Evolution for GCr15 Bearing Steel Warm-Hot Deformation Process

State-of-the-Art Review of the Simulation of Dynamic Recrystallization

Microstructure Evolution Modeling and Simulation for Dynamic Recrystallization of Cr12MoV Die Steel During Hot Compression Based on Real Metallographic Image

Numerical simulation and experimental validation of microstructure evolution during the upsetting process of a large size martensitic stainless steel forging

Research on hot deformation, dynamic recrystallization and numerical simulation of Fe–28Mn–10Al–1.5C–0.6V steel

Modelling Dynamic Recrystallization of A356 Aluminum Alloy during Hot Deformation

Numerical simulation on recrystallization behavior and microstructure evolution during hot continuous rolling process of 38CrMoAl steel rod

Prediction of microstructure evolution of Al–1% Mg alloy during hot forming and sequential heat treatment

Simulation of dynamic recrystallization in an Al-Mg-Si alloy during inhomogeneous hot deformation

An Integrated Simulation of Multiple-Pass U-10Mo Alloy Hot Rolling and Static Recrystallization

Study on Dynamic Recrystallization of Nb-Microalloyed Steels

Microstructure evolution, constitutive modeling and forming simulation of AA6063 aluminum alloy in hot deformation

Model of Metal Microstructure Evolution Considering Shear Effect and Its Simulation Application in Rolling of Heavy Cylinders

Dynamic Softening Mechanism on Steel of ASME SA508-3 During Hot Working