Abstract:The hot deformation behaviors of Fe–28Mn–10Al–1.5C–0.6V steel at T = 950–1150 °C and = 0.01–10 s −1 were studied using the Gleeble-3500 thermo-mechanical simulator. The constitutive model of Fe–28Mn–10Al–1.5C–0.6V steel was established by an artificial neural network (ANN) based on the experimental flow stress data. The critical conditions of dynamic recrystallization (DRX) of the steel under experimental conditions were studied by using both the Najafizadeh–Jonas work hardening rate model and the Cingara–McQueen rheological stress model. The true stress–true strain curve of the steel was analyzed, the work hardening rate was calculated, and the critical strain model was established. At the same time, the relevant material parameters were calculated by linear regression, and the DRX kinetics model of JMAK was also established. This model then was combined with the finite element software DEFORM-3D to simulate the DRX behavior of the steel during hot deformation. These results indicated that the rheological stress of Fe–28Mn–10Al–1.5C–0.6V steel at low shows higher temperature sensitivity and that high T and low are conducive to the occurrence of DRX. The average relative error of the ANN constitutive model is 2.40%, which has high prediction accuracy. The dynamic recrystallization conditions determined by the above models are reliable and conform to the experimental rules. By verifying the microstructure of the steel after thermal compression, the prediction error of the finite element model to the DRX volume fraction is mostly within 10%. Thus, the model has a good predictive ability and provides an effective tool for predicting plastic deformation and microstructure in industrial production.

Numerical simulation on recrystallization behavior and microstructure evolution during hot continuous rolling process of 38CrMoAl steel rod

Numerical Simulation of Microstructure Evolution During Continuous Hot Rolling Process of GCr15 Steel Rod

NONLINEAR THREE-DIMENSIONAL SIMULATION FOR HOT CONTINUOUS ROLLING OF STRIP STEEL

Multi-Scale Modeling of Microstructure Evolution during Multi-Pass Hot-Rolling and Cooling Process

Numerical simulation of continuous hot rolling process for ultra-thick SiCp/2009Al composites plate

Numerical Simulation on Solidification Structure of 30Cr(2)Ni(4)MoV Steel Under Different Temperature Gradient Using Procast Software

Numerical Simulation of Microstructure Evolution of Large GCr15 Bar During Multi-Pass Rough Rolling

Rheological Behavior and Microstructure Evolution of Continuous Roll-Casting Process

Microstructure simulation and experiment investigation of dynamic recrystallization for ultra high strength steel during hot forging

Research on hot deformation, dynamic recrystallization and numerical simulation of Fe–28Mn–10Al–1.5C–0.6V steel

Numerical Simulation on Recrystallization of Coarse-Grained Austenite in Low-Carbon Nb-microalloyed Steel

An Integrated Simulation of Multiple-Pass U-10Mo Alloy Hot Rolling and Static Recrystallization

Microstructure evolution of 38MnVS6 non-quenched steel bar during cooling process after hot rolling

Implementation of Experimental Static Recrystallization of High Strength Steel into Computational Simulation of Multi-pass Slab Hot Rolling

Microstructure Evolution in Nb-Ti Micro-Alloyed Steel During Hot Compression and Hot Rolling Simulation

Application of Mathematical Model for Microstructure and Mechanical Property of Hot Rolled Wire Rods

Numerical Simulation Research on the Temperature Field and Hot Roll Crown Model of Hot Continuous Rolling Mills

Numerical simulation and experimental verification of microstructure evolution in a three-dimensional hot upsetting process

The Influence of Hot Rolling Technological Parameters on Microstructure of Low Temperature Grain-Oriented Silicon Steel

Analytic Numerical Modeling for Thermal Mechanical Processing of Plate under Rolling

Simulation of Multi-pass Hot Rolling Process of Direct-chilled AZ31B Magnesium Alloy