Abstract:The hot deformation behaviors of Fe–28Mn–10Al–1.5C–0.6V steel at T = 950–1150 °C and = 0.01–10 s −1 were studied using the Gleeble-3500 thermo-mechanical simulator. The constitutive model of Fe–28Mn–10Al–1.5C–0.6V steel was established by an artificial neural network (ANN) based on the experimental flow stress data. The critical conditions of dynamic recrystallization (DRX) of the steel under experimental conditions were studied by using both the Najafizadeh–Jonas work hardening rate model and the Cingara–McQueen rheological stress model. The true stress–true strain curve of the steel was analyzed, the work hardening rate was calculated, and the critical strain model was established. At the same time, the relevant material parameters were calculated by linear regression, and the DRX kinetics model of JMAK was also established. This model then was combined with the finite element software DEFORM-3D to simulate the DRX behavior of the steel during hot deformation. These results indicated that the rheological stress of Fe–28Mn–10Al–1.5C–0.6V steel at low shows higher temperature sensitivity and that high T and low are conducive to the occurrence of DRX. The average relative error of the ANN constitutive model is 2.40%, which has high prediction accuracy. The dynamic recrystallization conditions determined by the above models are reliable and conform to the experimental rules. By verifying the microstructure of the steel after thermal compression, the prediction error of the finite element model to the DRX volume fraction is mostly within 10%. Thus, the model has a good predictive ability and provides an effective tool for predicting plastic deformation and microstructure in industrial production.

Implementation of Experimental Static Recrystallization of High Strength Steel into Computational Simulation of Multi-pass Slab Hot Rolling

Modeling of Dynamic Recrystallization Kinetics of a High Strength Low Alloy Steel During Hot Rolling

Simulation of deformation and static recrystallization in the stress relaxation test

An Integrated Simulation of Multiple-Pass U-10Mo Alloy Hot Rolling and Static Recrystallization

Numerical simulation on recrystallization behavior and microstructure evolution during hot continuous rolling process of 38CrMoAl steel rod

Dynamic Recrystallization Behavior and Constitutive Modeling of As-Cast 30cr2ni4mov Steel Based on Flow Curves

Microstructure simulation and experiment investigation of dynamic recrystallization for ultra high strength steel during hot forging

A Multi-Phase Model for Transformation Plasticity Using Thermodynamics-Based Metallurgical Algorithm

An Analysis of Dynamic Recrystallization During the Reduction Pretreatment Process Using a Multiscale Model

Research on hot deformation, dynamic recrystallization and numerical simulation of Fe–28Mn–10Al–1.5C–0.6V steel

Modelling of Dynamic Recrystallization in Hot Working

Multi-Scale Modeling of Microstructure Evolution during Multi-Pass Hot-Rolling and Cooling Process

Microstructure-Based Multiscale Analysis of Hot Rolling of Duplex Stainless Steel Using Various Simulation Software

Study on dynamic recrystallization of ultra-high strength 22MnB5 steel during hot rolling

Prediction of microstructure evolution of Al–1% Mg alloy during hot forming and sequential heat treatment

High-resolution simulating of grain substructure in cold rolling and its effects on primary recrystallization in annealing of ferritic stainless steel

Study on Dynamic Recrystallization of Nb-Microalloyed Steels

Static softening behavior of 316L stainless steel under flexible rolling process

Quantification of static softening process and its effects on work hardening characteristics of a typical high strength steel during multi-pass deformation

Dynamic Recrystallization Behavior of Low‐Carbon Steel during the Flexible Rolling Process: Modeling and Characterization

Modelling of Microstructure Evolution During Hot Rolling of a High-Nb HSLA Steel