Abstract:Warm deformation is a plastic-forming process that differs from traditional cold and hot forming techniques. At the macro level, it can effectively reduce the problem of high deformation resistance in cold deformation and improve the surface decarburization issues during the hot deformation process. Microscopically, it has significant advantages in controlling product structure, refining grain size, and enhancing product mechanical properties. The Gleeble-1500D thermal-mechanical physical simulation system was used to conduct isothermal compression tests on GCr15 bearing steel. The tests were conducted at temperatures of 600-1050 °C and strain rates of 0.01-5 s-1. Based on the experimental data, the critical strain model and dynamic recrystallization model for the warm-hot forming of GCr15 bearing steel were established in this paper. The model accuracy is evaluated using statistical indicators such as the correlation coefficient (R). The dynamic recrystallization model exhibits high predictive accuracy, as indicated by an R-value of 0.986. The established dynamic recrystallization model for GCr15 bearing steel was integrated into the Forge® 3.2 numerical simulation software through secondary program development to simulate the compression process of GCr15 warm-hot forming. The dynamic recrystallization fraction was analyzed in various deformation regions. The grain size of the severe deformation zone, small deformation zone, and difficult deformation zone was compared based on simulated compression specimens under the conditions of 1050 °C and 0.1 s-1 with the corresponding grain size obtained with measurement based on metallographic photos; the relative error between the two is 5.75%. This verifies the accuracy of the established dynamic recrystallization and critical strain models for warm-hot deformation of GCr15 bearing steel. These models provide a theoretical basis for the finite element method analysis and microstructure control of the warm-hot forming process in bearing races.

Simulation of deformation and static recrystallization in the stress relaxation test

Implementation of Experimental Static Recrystallization of High Strength Steel into Computational Simulation of Multi-pass Slab Hot Rolling

Modeling of Dynamic Recrystallization Kinetics of a High Strength Low Alloy Steel During Hot Rolling

Modelling time-dependent relaxation behaviour using physically based constitutive framework

Dynamic Recrystallization Behavior and Constitutive Modeling of As-Cast 30cr2ni4mov Steel Based on Flow Curves

Modeling of Dynamic Recrystallization Evolution for Cr8 Alloy Steel and Its Application in FEM

Mathematical modeling for dynamic recrystallization behavior of 40Cr steel

Numerical Simulation of Microstructure Evolution for SA508-3 Steel During Inhomogeneous Hot Deformation Process

Modeling and Verification of Stress Relaxation Behavior of Ti-6Al-4V

Static softening behavior of 316L stainless steel under flexible rolling process

Static Recrystallization Behavior of Twin Roll Cast Low-Carbon Steel Strip

Simulation of dynamic recrystallization in an Al-Mg-Si alloy during inhomogeneous hot deformation

A Unified Constitutive Model of Stress Relaxation of Ti-6Al-4V Alloy with Different Temperatures from Elastic to Plastic Loading

Study on Dynamic Recrystallization of Nb-Microalloyed Steels

Analysis and Modeling of Stress-Strain Curves in Microalloyed Steels Based on a Dislocation Density Evolution Model

Research on Dynamic Recrystallization of the Microalloyed Forging Steels

Finite Element Analysis of Dynamic Recrystallization Model and Microstructural Evolution for GCr15 Bearing Steel Warm-Hot Deformation Process

Cellular Automata Simulation of Dynamic Recrystallization Behavior of AZ81-1Y Magnesium Alloy Based on Laasraoui–Jonas Model

Investigation on Post-Deformation Recrystallization Behavior of 22MnB5 Steel based on Stress Relaxation

Modelling Dynamic Recrystallization of A356 Aluminum Alloy during Hot Deformation

Modelling of Dynamic Recrystallization in Hot Working