Abstract:High-performance extruded aluminum alloys with complex textures suffer significant dimension variation under environmental temperature fluctuations, dramatically decreasing the precision of navigation systems. This research mainly focuses on the effect of the texture of extruded pure aluminum on its dimensional stability after various annealing processes. The result reveals that a significant increment in the area fraction of recrystallized grains with orientation and a decrement in the area fraction of grains with orientation were found with increasing annealing temperature. Moreover, with the annealing temperature increasing from 150 °C to 400 °C, the residual plastic strain after twelve thermal cycles with a temperature range of 120 °C was changed from −1.6 × 10−5 to −4.5 × 10−5. The large amount of equiaxed grains with orientation was formed in the microstructure of the extruded pure aluminum and the average grain size was decreased during thermal cycling. The area fraction of grain with crystallographic orientation of the sample annealed at 400 °C after thermal cycling was 30.9% higher than annealed at 350 °C (23.7%) or at 150 °C (18.7%). It is attributed to the increase in the proportion of recrystallization grains with direction as the annealing temperature increases, provided more nucleation sites for the formation of fine equiaxed grains with orientation. The main orientation of the texture was rotated from parallel to to parallel to after thermal cycling. The change in the orientation of grains contributed to a change in interplanar spacing, which explains the change in the dimension along the extrusion direction during thermal cycling.

Influence Of Recrystallization Annealing On The Cube Texture In High-Purity Aluniinuni Foils

Influence Of Trace Re And Annealing On The Recrystallization Textures Of High Purity Al Anode Foils

Micro-process of Cube Texture Formation in High Purity Aluminum Foils by Cross Shear Rolling

Increasing Cube Texture in High Purity Aluminium Foils for Capacitors

Development and Stability During High Temperature Annealing of the Cube Texture in Rolled Ni Substrate Materials

Recrystallization behavior and texture evolution during annealing of cryogenic-rolled 3003 aluminum alloy

On the Relationship between Thermomechanical Processing Parameters and Recrystallization Texture in AA1100 Aluminum Alloy

Effect of heating rate during annealing on microstructure and texture evolution of AA8021 aluminum foil

Effect of Annealing Process on the Microstructure and Texture of Cold-Rolled High-Purity Al-0.5%Cu Plates

Effect of Residual Deformation Energy and Critical Heating Rate on Cubic Texture and Grain Growth Behavior of Severely Deformed Aluminum Foil

Effect of Alloying Elements and Processing Parameters on Microstructure and Properties of 1XXX Aluminium Alloys

Development of the Cube Texture at Low Annealing Temperatures in Highly Rolled Pure Nickel

Effect of different deformation and annealing procedures on non-magnetic textured Cu60Ni40 alloy substrates

Effect of Microstructure on the Dimensional Stability of Extruded Pure Aluminum

The Dependence of Final Microstructure, Texture Evolution and Mechanical Properties of Al–Mg–Si–Cu Alloy Sheets on the Intermediate Annealing

Recovery and Recrystallization in Commercial Purity Aluminum Cold Rolled to an Ultrahigh Strain

Influence of Intermediate Annealing on the Microstructure and Texture of Ni-9.3at%W Substrates

Evolution of Microstructure and Texture During Recovery and Recrystallization in Heavily Rolled Aluminum

Cube Texture Development in Pure Ni during Annealing in a High Strength Magnetic Field

Influence of Postdeposition Annealing on Crystallinity of Zinc Oxide Films

Deformation And Annealing Textures Of Extruded And Cold Rolled Pure Ni Single Crystals Of Cube Orientation