Abstract:Single-crystal quartz material is widely applied in the manufacture of resonators and sensors, but it is difficult to process because of its high hardness. A novel way to fabricate single-crystal quartz structures is proposed in this paper; the method includes quartz-on-silicon (QoS) technology and inductively coupled plasma (ICP) etching, which makes it feasible to fabricate complex structures with crystal quartz. The QoS method encompasses the bonding of silicon and quartz, followed by the thinning and polishing of quartz, which can enable the fabrication of an ultra-thin quartz wafer on silicon. In this way, instead of the conventional wet etching with hydrofluoric acid, the quartz layer can be easily etched using the ICP dry-etching method. Then, the structure of the pure quartz material is obtained by removing the silicon wafer. In addition, the silicon layer can be processed into the appropriate structure. This aspect overcomes the difficulty of processing a complex structure of single-crystal quartz with different crystal orientations. Thin single-crystal quartz wafers of Z-cut with a thickness of less than 40 μm were obtained by using this method, and a complex three-dimensional structure with an 80 μm width was also acquired by the ICP etching of the quartz wafer. The method can be applied to make both crystal-oriented quartz-based sensors and actuators, such as quartz resonant accelerometers.

Fabrication of Microresonators by Using Photoresist Developer As Etchant*

Fabrication of high-Q microresonators in dielectric materials using a femtosecond laser: Principle and applications

Femtosecond Laser Direct Writing of High-Q Microresonators in Glass and Crystals

Fabrication of High-Q Crystalline Microresonators by Femtosecond Laser Direct Writing for Phase Matched Second Harmonic Generation

Fabrication and Analysis of a Fabry-Perot Cavity with a Micromechanical Wet-Etching Process.

Novel Method of Fabricating Fabry-Perot Cavity Employing MEMS Wet-Etching Process

A Novel Method to Fabricate On-Chip Ultra-High-q Microtoroid Resonators

Superconducting Coplanar Waveguide Resonators Capable of Cofabrication with Josephson Junctions

Fabrication of 1-d nanochannels on PMMA substrate by photoresist-free uv lithography and UV-assisted bonding under low temperature

Micro Etching Method Inside Microchannels

The key technologies in silicon based microwave and RF MEMS device fabrication

Research on a Micro-Processing Technology for Fabricating Complex Structures in Single-Crystal Quartz

A generalized foundry CMOS platform for capacitively-transduced resonators monolithically integrated with amplifiers

Fabrication of Monolithic Integrated MEMS Resonator with Wet-Release-monitoring Array

Fabrication of a microtoroidal resonator with picometer precise resonant wavelength.

More-than-Moore Microacoustics: A Scalable Fabrication Process for Suspended Lamb Wave Resonators

Fabrication of High-Q Suspended AlGaAs Microresonators for Efficient Kerr Comb Generation

Inter-CMOS process for monolithic integrated MEMS resonator

Fabrication and Characterization of Piezoelectric Cantilever for Micro Transducers

Fabrication of MEMS Resonators in Thin SOI

Development Of An Electrochemical Micromachining Instrument For The Confined Etching Techniques