Abstract:In this article, a temperature-dependent threshold voltage extraction method based on noise measurement is proposed. This method induces a mathematical solution for acquiring channel temperatures ( ) of transistors in the saturation region to extract threshold voltages. In order to gain accurate channel temperature, a small-signal equivalent circuit model was established to determine transconductance ( ). Then, the extracted transconductance and measured noise power spectral density (NPSD) were used to obtain channel temperatures. On this basis, the temperature-dependent threshold voltage ( ) was derived. To validate the reliability of this method, a four-Fin six-finger N-FinFET and a four-Fin eight-finger N-FinFET were fabricated using the 14-nm bulk FinFET technology. In this study, the scattering parameters were obtained from 0.2 to 40.2 GHz. Also, the NPSDs were measured from 1 to 500 Hz, while gate voltage and drain voltage were set as 0.3, 0.49, and 0.75 V. Besides, the transistor – characteristics was also investigated when drain–source bias voltage changed from 0.05 to 0.9 V. Compared with the measurement results, the calculation results of drain–source current model using temperature-dependent threshold voltage achieved higher accuracy. Also, the root mean square errors (RMSEs) were less than 0.60% for four-Fin six-finger N-FinFET and less than 0.51% for four-Fin eight-finger N-FinFET. Therefore, the proposed extraction method can be applied to - ccurately predict transistor temperature-dependent threshold voltage.

An Improved Drain-Current Model for FinFETs

An improved computationally efficient drain current model for double-gate MOSFETs

Drain Current Model for Double Gate Tunnel-FETs with InAs/Si Heterojunction and Source-Pocket Architecture

Drain Current Model for Double Gate Tunnel-FETs with InAs/Si Heterojunction and Source-Pocket Architecture.

An improvement to computational efficiency of the drain current model for double-gate MOSFET

A More Accurate Potential-Based Drain Current Model for Bulk-Mosfets

Improved Analytical Model of Surface Potential with Modified Boundary Conditions for Double Gate Tunnel FETs.

Modeling, Simulation and Performance Analysis of Drain Current for Below 10 nm Channel Length Based Tri-Gate FinFET

An Improved Surface-Potential-Based Model for MOSFETs Considering the Carrier Gaussian Distribution

A physical based model to predict performance degradation of FinFET accounting for interface state distribution effect due to hot carrier injection

Comparison and insight into long-channel MOSFET drain current models

A Fully Analytical Current Model for Tunnel Field-Effect Transistors Considering the Effects of Source Depletion and Channel Charges

Role of Fin Shape on Drain Current of SiO2/HfO2 Based Trigate FinFET Including Quantum Mechanical Effect

Temperature-Dependent Threshold Voltage Extraction of FinFETs Using Noise Measurements

Calibration of Drift-Diffusion Model in Quasi-Ballistic Transport Region for FinFETs.

A drain current formula for two-dimensional field-effect transistors with one-shot convergence algorithm

Analytical Model of Channel Electric Field Profile in Finfet

An Experimentally Verified Temperature Dependent Drain Current Fluctuation Model for Low Temperature Applications

Analytical Drain Current Model for Long-Channel Gate-All-around Negative Capacitance Transistors with a Metal–ferroelectric–insulator–semiconductor Structure

Analytical Models for Threshold Voltage, Drain Induced Barrier Lowering Effect of Junctionless Triple-Gate Finfets

A 3D Charge Model for FinFETs with Ballistic Transport