Abstract:At present, there is a great interest in the development of new airfoils for wind turbines and high-lift wings of unmanned aerial vehicles (UAV). The requirements for such airfoils differ from conventional aircraft airfoils, because of structural reasons and extreme operating conditions. So, wind turbine airfoils operate frequently under fully separated flow when stall is used for power regulation at high wind speeds. At the same time design of airfoils for wings UAV poses the problem of availability of high-lift at low Reynolds number. Modern airfoils are to a large extent developed from numerical methods. However, the complex flow conditions such as separation at high angles of attack, laminar separation bubbles and the transition from laminar to turbulent flow are difficult to predict accurately. Hence, testing of airfoils at a two-dimensional condition is an important phase in airfoil design. The development and validation of a 2D testing facility for investigation of single and multi-element airfoils in the wind tunnel Т-102 with open test section are considered in this article. T-102 is a continuous-operation, closed-layout wind tunnel with two reverse channels. The test section has an elliptical cross-section of 4 ×2,33 m and a length of 4 m. Two big flat panels of the L × H=3 ×3,9 m size installed upright on balance frame aligned with the free stream are used for simulating two-dimensional flow in the tunnel test section. The airfoil section in the layout of a rectangular wing is mounted horizontally between flat panels with minimum gaps to ensure 2D flow conditions. The aerodynamic forces and pitch moment acting on the model were measured by wind tunnel balance. To determine boundary corrections for a new test section of wind tunnel, the experimental investigation of three geometrically similar models has been executed. The use of boundary corrections has provided good correlation of the test data of airfoil NACA 6712 with the results obtained from the wind tunnel except for lift and drag coefficient values at high angles of attack.

Similarity criteria and simulation method for flight control system of free-flight test in low speed wind tunnel

Low speed wind tunnel free-flight test of powered sub-scale aircraft

Development of Small-sized and Direct-current Calibration Wind Tunnel

Present Research Status and Prospective Application of Wind-Tunnel Free-Flight Test Technique

Rapid prototyping and implementation of flight control system for wind tunnel virtual flight test

Development of a Pilot-in-loop Real-Time Simulation Platform for Wind Tunnel Free-Flight Test

Overview of dynamic test techniques at low speed aerodynamics institute , cardc

Dynamic test experiment system of single degree of freedom of Φ3.2 m wind tunnel

Research about continuous scanning test technique based on non-contact measurement technique in low speed wind tunnel

Flight control simulation system design of a civil aircraft

Key technique for high angle of attack test of fighter aircraft in Φ3.2m low speed wind tunnel

Identification of Lateral-Directional Aerodynamic Parameters via an Online Correction Wind Tunnel Virtual Flight Test

A Similarity Comparison Method of Flight Test Points

Visual simulation research of post-stall maneuverability flight control laws based on Matlab/Flightgear/Atlas

Dynamics, stability, and control of a four-cable mount system for wind tunnel test

Simulation Testing Method of V/STOL Flight Control Strategy

Numerical validation of the dynamic aerodynamic similarity criterion for floating offshore wind turbines under equivalent pitch motions

SIMULATION OF 2D FLOW AROUND OF AIRFOILS AT LOW-SPEED WIND TUNNEL WITH OPEN JET TEST-SECTION

Nonlinear Control Laws for a Wind Tunnel Free-flight Study of a Canard Aircraft

Simulation for a Bridge Section Model's Wind Tunnel Test Based on Feedback Control

Experiment and study of a flight siumlator prototype system