Abstract:At present, there is a great interest in the development of new airfoils for wind turbines and high-lift wings of unmanned aerial vehicles (UAV). The requirements for such airfoils differ from conventional aircraft airfoils, because of structural reasons and extreme operating conditions. So, wind turbine airfoils operate frequently under fully separated flow when stall is used for power regulation at high wind speeds. At the same time design of airfoils for wings UAV poses the problem of availability of high-lift at low Reynolds number. Modern airfoils are to a large extent developed from numerical methods. However, the complex flow conditions such as separation at high angles of attack, laminar separation bubbles and the transition from laminar to turbulent flow are difficult to predict accurately. Hence, testing of airfoils at a two-dimensional condition is an important phase in airfoil design. The development and validation of a 2D testing facility for investigation of single and multi-element airfoils in the wind tunnel Т-102 with open test section are considered in this article. T-102 is a continuous-operation, closed-layout wind tunnel with two reverse channels. The test section has an elliptical cross-section of 4 ×2,33 m and a length of 4 m. Two big flat panels of the L × H=3 ×3,9 m size installed upright on balance frame aligned with the free stream are used for simulating two-dimensional flow in the tunnel test section. The airfoil section in the layout of a rectangular wing is mounted horizontally between flat panels with minimum gaps to ensure 2D flow conditions. The aerodynamic forces and pitch moment acting on the model were measured by wind tunnel balance. To determine boundary corrections for a new test section of wind tunnel, the experimental investigation of three geometrically similar models has been executed. The use of boundary corrections has provided good correlation of the test data of airfoil NACA 6712 with the results obtained from the wind tunnel except for lift and drag coefficient values at high angles of attack.

Overview of dynamic test techniques at low speed aerodynamics institute , cardc

Dynamic test experiment system of single degree of freedom of Φ3.2 m wind tunnel

Key technique for high angle of attack test of fighter aircraft in Φ3.2m low speed wind tunnel

Low speed wind tunnel free-flight test of powered sub-scale aircraft

Identification of Lateral-Directional Aerodynamic Parameters for Aircraft Based on a Wind Tunnel Virtual Flight Test

Present Research Status and Prospective Application of Wind-Tunnel Free-Flight Test Technique

Flight Dynamics Modeling and Aerodynamic Parameter Identification of Four-Degree-of-Freedom Virtual Flight Test

Identification of Aircraft Longitudinal Aerodynamic Parameters Using an Online Corrective Test for Wind Tunnel Virtual Flight

Airworthiness compliance validating technique for wind tunnel test of a civil aircraft low speed flutter model

Feasibility Study for the Development of Small Scale Low Speed Wind Tunnel for Supermileage Prototype Car

Similarity criteria and simulation method for flight control system of free-flight test in low speed wind tunnel

A High-speed Nature Laminar Flow Airfoil and Its Experimental Study in Wind Tunnel with Nonintrusive Measurement Technique

Computational investigation of simulation on the dynamic derivatives of flight vehicle

Aeroacoustic Measurement of 30P30N High-Lift Configuration in the Test Section with Kevlar Cloth and Perforated Plate

Initial Virtual Flight Test for a Dynamically Similar Aircraft Model with Control Augmentation System

Longitudinal Aerodynamic Parameter Identification for Blended-Wing-Body Aircraft Based on a Wind Tunnel Virtual Flight Test

Measurement technology in hypersonic wind tunnel

Modeling and simulation for a low speed wind tunnel virtual flight test rig

SIMULATION OF 2D FLOW AROUND OF AIRFOILS AT LOW-SPEED WIND TUNNEL WITH OPEN JET TEST-SECTION

Wind Tunnel Testing Techniques for a Tandem Tilt-Wing, Distributed Electric Propulsion VTOL Aircraft

Design and Implementation of a Low-Speed Wind Tunnel System