Abstract:Flapping flight has undoubtedly played a significant role in many of the aeronautical engineering achievements in the past several centuries. Flapping motions of wings/fins are used by animals (such as birds, insects and bats) to generate lift or thrust to keep them aloft in the surrounding fluid. Researches in this area are not only motivated by the fundamental interest of understanding the mechanism of flapping flight, but also the development of Micro Air Vehicles (MAVs) based on biomimetics. In this lecture, we will address our efforts towards both experimental studies and virtual testing of flapping flight with our High End Digital Prototyping (HEDP) system. The aim of our research is to use physical and biological models to drive the engineering design of these vehicles. Firstly, two types of flapping-wing Unmanned Air Vehicles (UAVs) with spatial four-bar drive mechanism will be presented, including the wind tunnel experiment and prototype flight test results. Secondly, various computation approaches have been adopted to simulate the flapping motions, including traditional moving mesh techniques based on Arbitrary Lagrangian Eulerian (ALE) formulation, and Lattice Boltzmann method with immersed boundary methods. For a single wing-system, we have investigated the influences of various parameters on both the symmetric flapping and asymmetric flapping with bird-like or turtle-like flapping mode. For a tandem wing system, we have investigated the interaction between the hind wing and the vortex shedding off the fore wing and learned how to utilize the flow mechanism to achieve better aerodynamic performances. Moreover, Dynamic Mode Decomposition (DMD) algorithm has been adopted to reveal the underlying physics due to its capability and accuracy in analyzing the complex transient systems. Finally, the flight control design of a dragonfly-like Flapping Wing Micro Aerial Vehicle (FWMAV) is presented, which has incorporated a Linear-Quadratic Regulator (LQR) method and an Iterative Learning Tuning (ILT). In general, we expect that these virtual testing by computational simulations and flight control can drive the design of our next generation flapping-wing UAVs in the future.

Present Research Status and Prospective Application of Wind-Tunnel Free-Flight Test Technique

NUMERICAL WIND TUNNEL TECHNIQUE FOR THE WIND RESISTANCE ANALYSIS OF LONG SPAN SPATIAL STRUCTURES

Development of a Pilot-in-loop Real-Time Simulation Platform for Wind Tunnel Free-Flight Test

Towards Virtual Testing of Flapping Flight

Low speed wind tunnel free-flight test of powered sub-scale aircraft

Overview of dynamic test techniques at low speed aerodynamics institute , cardc

Similarity criteria and simulation method for flight control system of free-flight test in low speed wind tunnel

Rapid prototyping and implementation of flight control system for wind tunnel virtual flight test

Key technique for high angle of attack test of fighter aircraft in Φ3.2m low speed wind tunnel

Dynamic test experiment system of single degree of freedom of Φ3.2 m wind tunnel

Identification of Lateral-Directional Aerodynamic Parameters via an Online Correction Wind Tunnel Virtual Flight Test

Research about continuous scanning test technique based on non-contact measurement technique in low speed wind tunnel

Free-Running tests for the rapidity of the aerodynamic lift-increasing planing craft

Measurement technology in hypersonic wind tunnel

Research of a novel aerodynamic evaluation method for fixed-wing UAV

Low Observable Uncrewed Aerial Vehicle Wind Tunnel Model Design, Manufacturing, and Aerodynamic Characterization

Extended Study of Full-Scale Wind Tunnel Test and Simulation Analysis Based on DrivAer Model

Unsteady test technique of jet control with multi-parameter coupling

Numerical Simulation and Experimental Study on the Aerodynamics of Propulsive Wing for a Novel Electric Vertical Take-Off and Landing Aircraft

Numerical and Experimental Investigation of A Three-Axis Free Rotation Wind Tunnel Model

Research on Aerodynamic Test Validation and the Vector Force Control Method for an E-STOL Fan Wing Unmanned Aerial Vehicle