Abstract:At present, there is a great interest in the development of new airfoils for wind turbines and high-lift wings of unmanned aerial vehicles (UAV). The requirements for such airfoils differ from conventional aircraft airfoils, because of structural reasons and extreme operating conditions. So, wind turbine airfoils operate frequently under fully separated flow when stall is used for power regulation at high wind speeds. At the same time design of airfoils for wings UAV poses the problem of availability of high-lift at low Reynolds number. Modern airfoils are to a large extent developed from numerical methods. However, the complex flow conditions such as separation at high angles of attack, laminar separation bubbles and the transition from laminar to turbulent flow are difficult to predict accurately. Hence, testing of airfoils at a two-dimensional condition is an important phase in airfoil design. The development and validation of a 2D testing facility for investigation of single and multi-element airfoils in the wind tunnel Т-102 with open test section are considered in this article. T-102 is a continuous-operation, closed-layout wind tunnel with two reverse channels. The test section has an elliptical cross-section of 4 ×2,33 m and a length of 4 m. Two big flat panels of the L × H=3 ×3,9 m size installed upright on balance frame aligned with the free stream are used for simulating two-dimensional flow in the tunnel test section. The airfoil section in the layout of a rectangular wing is mounted horizontally between flat panels with minimum gaps to ensure 2D flow conditions. The aerodynamic forces and pitch moment acting on the model were measured by wind tunnel balance. To determine boundary corrections for a new test section of wind tunnel, the experimental investigation of three geometrically similar models has been executed. The use of boundary corrections has provided good correlation of the test data of airfoil NACA 6712 with the results obtained from the wind tunnel except for lift and drag coefficient values at high angles of attack.

Key technique for high angle of attack test of fighter aircraft in Φ3.2m low speed wind tunnel

Development of Small-sized and Direct-current Calibration Wind Tunnel

Dynamic test experiment system of single degree of freedom of Φ3.2 m wind tunnel

NUMERICAL WIND TUNNEL TECHNIQUE FOR THE WIND RESISTANCE ANALYSIS OF LONG SPAN SPATIAL STRUCTURES

Overview of dynamic test techniques at low speed aerodynamics institute , cardc

Research about continuous scanning test technique based on non-contact measurement technique in low speed wind tunnel

Φ120 Hypersonic Wind Tunnel Flow Field Calibration

Study on the support interference of wire-assistant sting support at high angle of attack in low speed wind tunnel

Aero-Elastic Wind Tunnel Test of A High Lighting Pole

Present Research Status and Prospective Application of Wind-Tunnel Free-Flight Test Technique

Measurement technology in hypersonic wind tunnel

Aeroacoustic Measurement of 30P30N High-Lift Configuration in the Test Section with Kevlar Cloth and Perforated Plate

Low speed wind tunnel free-flight test of powered sub-scale aircraft

Research on Movement Relationship and Multi-Axis Motion Control Strategy for the Big Attack Angle Device of the Low-Speed Wind Tunnel

SIMULATION OF 2D FLOW AROUND OF AIRFOILS AT LOW-SPEED WIND TUNNEL WITH OPEN JET TEST-SECTION

Similarity criteria and simulation method for flight control system of free-flight test in low speed wind tunnel

The wind tunnel test research on the aerodynamic stability of wind turbine airfoils

Experimental research on the high angle of attack aerodynamic characteristics of an 80°/65° double-delta wing

Design and characterization of a multifunctional low-speed anechoic wind tunnel at HKUST

Design, validation, and benchmark tests of the aeroacoustic wind tunnel in SUSTech

Force Measurement and Support Integrated Device in Hypersonic Wind Tunnel