Abstract:<p>Dents have been identified as among the most common deformation defects in oil and gas pipelines. In this study, the multidimensional mechanical responses, springback, and rerounding behaviors of dents as well as the interaction of multiple dents on pipelines and their effect on pipe integrity were investigated through the three-dimensional finite element method and full-scale burst tests. The burst test demonstrates that a plain dent has a minimal effect on the pipeline burst pressure, and the burst failure position is not located in the dented area. Generally, when a dented pipeline that is subjected to monotonically increasing internal pressure bursts, the dent does not fully reround, and a convex protuberance forms in the axial shoulders on both sides of the dent. During pressurization, the maximum equivalent plastic strain in the dented pipe always occurs on the inner surface near the dent center in which no necking is found in the radial direction of the wall thickness. However, a larger equivalent stress is observed around the edge of the dent center, whereas the stress at the center is relatively small, resulting in the formation of a plastic hinge in the dented area. If internal pressure fluctuations occur, this can easily lead to fatigue failure. Finally, the interaction among multiple longitudinally aligned dents was investigated, and the critical spacing affecting the integrity of the pipeline was determined. The investigation reveals that when the dent spacing exceeds the pipe diameter, the interaction between two dents may be ignored, and the dent effect on the pipe integrity may be separately evaluated. However, if the dent spacing is less than 0.5 times the pipe diameter, then the dents must be treated as a combined dent. Further, if the spacing is 0.5–1.0 times the pipe diameter, then dent interaction must be considered.</p>

Dynamic Response of Pressurized Gas Pipes Subjected to Transverse Impact Loads

A Numerical Study on the High-Velocity Impact Behavior of Pressure Pipes

Numerical Study of CFRP-Bonded Pressure Pipes Subject to Impact Load

Local buckling of deepwater oil-gas pipeline under high hydrostatic pressure

Study of Dynamic Fracture Behavior of Pressure Pipes

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

An Experimental Investigation on the Impact Perforation Failure of Water-Filled-Pressurized Pipelines

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Prediction Of Internal Pressure Of Flexible Pipe

Incremental Dynamic Crack Propagation of Pipe Subjected to Internal Gaseous Detonation

A Three-Dimensional Analytical Solution for Sandwich Pipe Systems under Linearly Varying External Pressures

Analysis of Plastic Deformation of Pipes Due to Deflagration to Detonation Transition Using Static Equivalent Pressure

Effect of the Y/T on the Burst Pressure for Corroded Pipelines with High Strength

Fracture Response of X80 Pipe Girth Welds under Combined Internal Pressure and Bending Moment

Dynamic Ductile Fracture Toughness Test and Numerical Simulation for Ultra-High Pressure Gas Pipelines

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

Damage Characterization of GFRP Hollow Ribbed Emergency Pipes Subjected to Low-Velocity Impact by Experimental and Numerical Analysis

Dynamic Response of Buried Natural Gas Pipelines under Horizontal Directional Drilling Loads

The destructive form and response analysis of buried concrete pipes under the action of internal explosion loads

Behavior of Flexible Pipe Subjected to Internal Pressure

Multi-dimensional mechanical response of multiple longitudinally aligned dents on pipelines and its effect on pipe integrity