Abstract:The paper proposes a novel transceiver in physical layer for high-speed serial data link based upon Universal Serial Bus (USB) 2.0, comprising transmitter and receiver. In the design, transmitter contains pre-and-main driver to satisfy slew rate of output data, receiver includes optimized topology to improve precision of received data. The circuit simulation is based on Cadence’s spectre software and Taiwan Semiconductor Manufacture Corporation’s library of 0.25μm mixed-signal Complementary Metal-Oxide Semiconductor (CMOS) model. The front and post-simulation results reveal that the transceiver designed can transmit and receive high-speed data in 480Mbps, which is in agreement with USB2.0 specification. The chip of physical-layer transceiver has been designed and implemented with 0.25μm standard CMOS technology.

The Design and Development of USB 2.0 Interface IP Core

Design and Implementation of the High-Performance Link Layer in High-Speed Serial Communication

Design of Data Communication Interface of Data Acquirement System Based on USB

Design and Implementation of a High-speed USB Device Controller IP Core

A Novel Physical-Layer Transceiver Used in USB2.0 Serial Data Link

Design and verification of USB2.0 device IP core integreted without MCU

Design and Implementation of USB1.1 Device Controller IP Core

Design of the operating mode control cicurt of the USB2 . 0 device controller

Real-time Bidirectional Data Transmission Based on USB Interface

IP core design of USB 2.0 device controller with 8051

Designs of USB2.0 interface of data acquisition card

USB digital I/O device design based On FPGA

Design of Duplex Interface Between FPGA and USB2.0

Analysis and Frame Design of USB3.0 Protocol

Research on Software-hardware Co-design Methodology for USB2.0 Host Controller in SoC System

Low Pin Count Interface for USB2.0 Host Controller in SOC System

System design of cryptographic security USB device controller IP core

Design of USB2.0 Protocol Analyzer Based on FPGA

Design and Implementation of USB1.1 Controller

USB Peripheral Device and its FPGA Implementation

Design of an FPGA-based USB 3.0 device controller