Abstract:This paper introduces the design and implementation of essential modules in a class 4 Multifunctional Vehicle Bus (MVB) controller. The MVB controller is responsible for polling and storing the information collected by up to 4096 different sensors deployed in a carriage of high-speed trains. Working under strict real-time constraints, the MVB network controller consists of both firmware running on FPGA and software executed on an ARM processor. The operation of the card is under hostile electromagnetic environments. This paper consists of firmware design of the interface module to the industrial computer, command processing unit module and memory controller module. The designed modules offer full support for dynamic configuration, which significantly lower the complexity of system management. In addition to completely meeting the real-time and functional requirements specified by IEC61375, the circuits are carefully designed to support fault tolerance and fast recovery. The network controller has passed the protocol conformance test and 15-day fault-free field test on the sub-way trains.

Design and Implementation of USB1.1 Controller

Design of Data Communication Interface of Data Acquirement System Based on USB

Design and Implementation of the High-Performance Link Layer in High-Speed Serial Communication

A Novel Physical-Layer Transceiver Used in USB2.0 Serial Data Link

Design of GAP-based network security device

Design of USB Floppy Driver Based on WinCE

Real-time Bidirectional Data Transmission Based on USB Interface

Design and implementation of controller for a sensor network protocol

Design and Implementation of FPGA Based High-Speed Bus for Control System

Design and Realization of Low Cost USB Protocol Converter

The Design and Development of USB 2.0 Interface IP Core

Design and FPGA Verification of a Novel Reliable Real-Time Data Transfer System

Design of an FPGA-based USB 3.0 device controller

Design of the operating mode control cicurt of the USB2 . 0 device controller

USB Peripheral Device and its FPGA Implementation

In System Programming Design of 51 Microcontroller Base on USB Interface

Design of device driver based on stream interface driver model under WinCE

Implementation of a USB2.0 Device Based on SOPC

Design of USB HID Device Based on Single Chip C8051f340

Design of Data Transmission System Based on FPGA and USB 2.0

The Design and Implementation of PC/104-Compatible Interface and Traffic Store Hardware in a Class 4MVB Controller