Abstract:The paper proposes a novel transceiver in physical layer for high-speed serial data link based upon Universal Serial Bus (USB) 2.0, comprising transmitter and receiver. In the design, transmitter contains pre-and-main driver to satisfy slew rate of output data, receiver includes optimized topology to improve precision of received data. The circuit simulation is based on Cadence’s spectre software and Taiwan Semiconductor Manufacture Corporation’s library of 0.25μm mixed-signal Complementary Metal-Oxide Semiconductor (CMOS) model. The front and post-simulation results reveal that the transceiver designed can transmit and receive high-speed data in 480Mbps, which is in agreement with USB2.0 specification. The chip of physical-layer transceiver has been designed and implemented with 0.25μm standard CMOS technology.

Implementation of a USB2.0 Device Based on SOPC

Design of Data Communication Interface of Data Acquirement System Based on USB

Design and Implementation of the High-Performance Link Layer in High-Speed Serial Communication

Design of USB Floppy Driver Based on WinCE

A Novel Physical-Layer Transceiver Used in USB2.0 Serial Data Link

USB Peripheral Device and its FPGA Implementation

The Design and Development of USB 2.0 Interface IP Core

Design and Realization of Low Cost USB Protocol Converter

An Implementation Scheme of Embedded IP Gateway Based on SOPC

Implementation of Gigabit Ethernet Network Based on SOPC

Implementing an SCSI application system based on SOPC technology

Real-time Bidirectional Data Transmission Based on USB Interface

Design and Implementation of USB1.1 Controller

Implementing a SCSI application system based on SOPC technology

Study on Implementation of SCSI Application System Based on SOPC

Research on Software-hardware Co-design Methodology for USB2.0 Host Controller in SoC System

Design of device driver based on stream interface driver model under WinCE

Low Pin Count Interface for USB2.0 Host Controller in SOC System

Design of the operating mode control cicurt of the USB2 . 0 device controller

Design of Data Transmission System Based on FPGA and USB 2.0

Design of an FPGA-based USB 3.0 device controller