Abstract:A power-efficient and low-cost 1.0625–3.125 Gb/s serial transceiver is presented in this paper for Fiber Channel(FC),Peripheral Component Interconnect Express(PCIe),and RapidIO applications.To support multiple standards with a single low power and low cost design,the transceiver presented here uses a wide swing range source-series-terminated(SST)transmitter(TX),a passive receiver(RX)equalizer,a dual-loop phase locked loop(PLL)and a mixed signal clock and data recovery(CDR)unit.The proposed SST transmitter also realizes a 3bit 2-tap de-emphasis filter that compensates up to 6 dB on the transmitter,and a passive equalizer that achieves 4 dB transmission in the receiver.The dual-loop PLL with an on-chip regulator is used to generate a low-jitter clock for the TX and CDR’s reference.A CDR with a phase interpolator(PI)is proposed with a mixed signal structure to recover the clock on the RX and it can tolerate a frequency offset of up to 2000 ppm.The transceiver is fabricated in a 130 nm digital CMOS process and occupies an area of 0.8 mm2.With supply voltages of 1.2 V and 3.3 V,the transceiver dissipates 78 mW when compensating for a total loss of 10 dB at3.125 Gb/s.

A Novel Physical-Layer Transceiver Used in USB2.0 Serial Data Link

A dual-mode serial link transmitter with controlled slew rate

Design and Implementation of the High-Performance Link Layer in High-Speed Serial Communication

A Novel Data Processing Circuit in High-Speed Serial Communication

Design of monolithic Phase-Locked Loop circuit for high-speed serial data link

An 0.18μm High-Speed USB 2.0 Transceiver

Real-time Bidirectional Data Transmission Based on USB Interface

A 0.13μm Mixed-Signal CMOS High Speed USB 2.0 Transceiver

Research on USB Data Transmission Technology Based on LabVIEW

A Novel Transmitter in High-Speed Serial Data Communication

D-band CMOS Transmitter and Receiver for Multi-Giga-bit/sec Wireless Data Link

USB2 . 0 transceiver logic circuit design based on UTMI specification

Integrated D-Band Transmitter and Receiver for Wireless Data Communication in 65 Nm Cmos

A 2-Gb/s/pin Source Synchronous CDMA Bus Interface with Simultaneous Multi-Chip Access and Reconfigurable I/O Capability

A Power Efficient 1.0625-3.125 Gb/s Serial Transceiver in 130 Nm Digital CMOS for Multi-Standard Applications.

Transmitter for high-speed serial data communication

Design of Data Transmission System Based on FPGA and USB 2.0

Design and Realization of Low Cost USB Protocol Converter

A Novel Receiver in High-Speed Serial Data Link

High-speed serial interconnect transceiver: Applications and design

Design and Implementation of Infrared Data Transmission System Based on USB 2.0