Abstract:The health monitoring of cylindrical elements is particularly important for the safe operation of industrial production, because cylinders bear a lot of support and transmission work. Normal non-destructive evaluation techniques need special designs to suit high curvature surfaces of cylinders. Laser ultrasonic (LU) method can provide a remote and non-destructive inspection solution to solid cylinders due to its flexible adaptability to complex structures and strong penetration depth. However, constrained by the common problems of optical detection systems, the detected ultrasonic signals will suffer low signal-to-noise ratio and bad resolution from poor sample surface quality. Thus, a modified synthetic aperture focusing technique (SAFT) optimized for cylindrical components is proposed to improve the detectability of LU on small and buried defects. Mode conversion wave signals obtained by multiple separate excitations are used in SAFT imaging for the reconstruction of the defects under surface profile correction. To reduce the influence of incident waves such as direct surface acoustic wave, besides common difference method, adjacent wave subtraction algorithm based on cross-correlation is used for signal preprocessing, suppressing the incident waves and exaggerating the mode conversion waves. In numerical simulation, internal defects with diameters from 0.6 to 0.2mm with various buried depths are visualized and accurately located via the optimized SAFT algorithm using mode conversion waves. For validation, a circumferential scanning system is established in LU experiment and internal defects from 0.8 to 0.4mm in diameter inside solid cylinders are successfully detected with precise location. The results elucidate the reliability of characterizing the location of small internal buried defects in solid cylinder structures through LU-SAFT imaging.

Finite element based research on ultrasonic spectral characteristic of inner wall defect of metal materials

Nondestructive Evaluation of Special Defects Based on Ultrasound Metasurface

Scattering of Torsional Flexural Guided Waves from Circular Holes and Crack-Like Defects in Hollow Cylinders

Feasibility Research of Defect Testing for Basin Insulator Based on Ultrasonic Guided Wave

Detecting features of defect metal based on laser ultrasonic technique

Research of Ultrasonic Inspection for Complex Form Aircraft Forging Component

Finite element analysis on ultrasonic propagation of interface bonding of bimetal composites

Ultrasonic Inspection Of Localized Defects In Low-Porosity Cfrp

Numerical Simulation of Surface Acoustic Wave and Detection of Surface Crack in Steel

Ultrasonic Detection Method of Micro Defects in Thick-Section CFRP

Width and Depth Gauging of Rectangular Subsurface Defects Based on All-Optical Laser-Ultrasonic Technology

Numerical Simulation of the Ultrasonic Pulse Wave Propagation at Solid-Solid Interface

The Theoretical Analyse of the Surface Acoustic Waves Propagated on the Surface of the Bulk Materials with Subsurface Defect

Finite element analysis and experimental investigation of ultrasonic testing of internal defects in SiCp/Al composites

Application of Computer Finite Element Simulation to the Quantitative Inspection of Flaw MFL

Modeling Ultrasonic Elastic Waves in Fiber-Metal Laminate Structures in Presence of Sources and Defects

Nonlinear Ultrasonic Techniques for Testing Micro-Defects in Metal Matrix Composite Structure

Finite Element Analysis Model on Ultrasonic Phased Array Technique for Material Defect Time of Flight Diffraction Detection

Finite element simulation and experimental verification of ultrasonic non-destructive inspection of defects in additively manufactured materials

The Experimental Investigation of Ultrasonic Testing Sensitivity for Internal Surface Radial Defects in Cylindrical Item with Thick Wall

Characterization of internal defects in cylindrical components using laser ultrasonic method with a modified SAFT algorithm