Abstract:Based on the test results of 27 RC pullout test specimens and a cube block of step loading,the specimens with ZBL-U520 non-metallic ultrasonic detector were non-destructivly tested.The effects that the second harmonic was excited by receiver frequency and transmitter voltage were analyzed so as to determine the suitable test parameters.On the basis of the analysis,the specimens of different corrosion rates with nonlinear ultrasonic technology were non-destructively tested and non corroded specimens graded injury were non-destructively tested under a pullout test.The relationship of nonlinear ultrasonic characteristic parameters (the second harmonic and nonlinear coefficients) and different corrosion rates,different load damage were studied,applicability of nonlinear ultrasonic technology applied RC Non-destructive testing was verified.The results show that the receiving transducer frequency equals the transmitting transducer 2 times more than the second harmonic.Compared with the with spectrums of different voltage (65 V,125 V,250 V,500 V,1 000 V),it can be found that with the increase of transmitting voltage,the amplitude of the second harmonic also increased.So the emitter voltage is positioned 1 000 V to obtain more accurate nonlinear ultrasonic characteristic parameters within the limits permitted by the instrument.The second harmonic amplitude and nonlinear coefficient increases nonlinearly with the increase of corrosion rating and pulling force,The second harmonic amplitude and nonlinear coefficients of the specimens increased slowly under higher stirrup ratio and while thicker protective layer.In contrast,Increased rapidly,Tests showed that it's accurate and suitable to characterize the damage degree of reinforced concrete by using nonlinear ultrasonic technology to measure nonlinear ultrasonic characteristic parameters.

Research of applicability of non-destructive testing for damaged reinforced concrete basd on nonlinear ultrasonic technology

Feasibility of non-destructive testing for aluminium sheaths of HV cables using ultrasonic guided waves

Concrete damage diagnosed using the non-classical nonlinear acoustic method

In-situ nonlinear ultrasonic technique for monitoring damage in ultra-high performance fibre reinforced concrete (UHPFRC) during direct tensile test

Experimental Study on Bond Performance and Damage Detection of Corroded Reinforced Concrete Specimens

Corrosion damage detection in reinforced concrete using Rayleigh wave-based method

Acoustic Emission Study on the Damage Evolution of a Corroded Reinforced Concrete Column under Axial Loads

Axial stress measurement of concrete with nonlinear ultrasonic harmonic method

Research Progress in Nonlinear Ultrasonic Testing for Early Damage in Metal Materials

To Evaluate the Degradation of Heat Damaged Concrete Specimens after Curing Using Non-Linear Ultrasound Technique

Cracking Mechanism of Corroded Reinforced Concrete Column Based on Acoustic Emission Technique

Research on nonlinear ultrasonic NDT of microcracks

Measurement of Reinforcement Corrosion in Concrete Adopting Ultrasonic Tests and Artificial Neural Network

Quantification of Compression Induced Damage and Its Effect on the Chloride Transport in Structural Concrete

Study on Ultrasonic Nondestructive Testing of Self-Compacting Concrete under Uniaxial Compression Test

Characterization of Corrosion-Induced Fracture in Reinforced Concrete Beams Using Electrical Potential, Ultrasound and Low-Frequency Vibration

Concrete Microcracks Detection under Compressive Load Based on Nonlinear Ultrasonics Modulation with Broadband Excitation

Characterisation of corrosion-induced crack in concrete using ultrasonic diffuse coda wave

Combined Application of Novel Electromagnetic Sensors and Acoustic Emission Apparatus to Monitor Corrosion Process of Reinforced Bars in Concrete

Damage Assessment in Q690 High Strength Structural Steel Using Nonlinear Lamb Waves

A Comparative Study on Plastic Damage Characterization of Metallic and Organic Materials Based on Nonlinear Ultrasonic Technique