Abstract:The creep and nonlinear damage behavior of rocks are two main factors that can cause large deformations and instability in tunnels. In this paper, uniaxial compression creep and triaxial compression tests were conducted to analyze the time-dependent and damage-induced strain-softening response of sandstone obtained from a water-conveyance tunnel in China. Using the test results, a new constitutive model was developed by coupling damage mechanics, Maxwell and Kelvin viscoelastic models, and the Mohr–Coulomb failure criterion. The model is formulated to describe both the full creep process (including the three stages of transient, steady, and accelerated creep) and the damaged-induced strain-softening behavior of the sandstone. The proposed model was validated against experimental data and was adopted to investigate the long-term safety of the segmental liner of the water-conveyance tunnel. The results showed that the differences between the rock peak and residual strength or between the initial and residual stiffness of sandstone increased as the confining pressure increased. In addition, the ratio between the crack damage stress and the peak strength increased initially with the increase in confining pressure and then decreased with a further increase in confining pressure. The ratio between creep deformation and total deformation increased with the increase in applied stress, and the specimen exhibited significant creep behavior at the final loading stage. Furthermore, the steady creep rate increased, and the viscosity coefficient decreased with the increase in loading stress. Good agreement was found between the values of failure strengths and shapes of stress–stain curves between the numerical simulation and experimental results under the uniaxial unconfined compressive creep test or triaxial compressive test. The axial load and bending moment of the tunnel segmental liner increased with the increase in the yield strength of concrete. The plot of axial force along the entire segmental liner ring varied greatly with time, while the plot of bending moment was less affected by time.

Creep Characterization of Concrete Suffering Initial Damage

Numerical Method for Creep Analysis of Strengthened Fatigue-Damaged Concrete Beams

Constitutive model of concrete creep damage considering the deterioration of creep parameters

Study of the Healing Effect of Concrete with Supplementary Cementitious Materials after Early-Age Damage by Acoustic Emission Technique

Damage Based Constitutive Model for Predicting the Performance Degradation of Concrete

Viscoelastic–Plastic Constitutive Model Considering the Damage Characteristics of Concrete in the Process of Nonlinear Creep

Characterizing the effect of compressive damage on transport properties of cracked concretes

Chloride Penetration into Concrete Damaged by Uniaxial Tensile Fatigue Loading

Numerical Simulation of Fracture and Damage Behaviour of Concrete at Different Ages

Mesoscopic analysis of creep characteristics of hard tuff considering damage

Numerical modeling of delayed damage and failure of concrete structures under sustained loading

Cracking Behavior of Cfrp Laminate-Strengthened Rc Beams with Premechanical and Postmechanical Environmental Damage

Quantification of Compression Induced Damage and Its Effect on the Chloride Transport in Structural Concrete

Prediction on Crack Propagation of Concrete due to Time-Dependent Creep under High Sustained Loading

Coupled Creep-Damage-Plasticity Model for Concrete under Long-Term Loading

Damage and hardening evolution characteristics of sandstone under multilevel creep–fatigue loading

A Nonlinear Creep Damage Coupled Model for Rock Considering the Effect of Initial Damage

Modeling of the creep and nonlinear damage effects of rocks and its application in tunnels

Effects of creep recovery on the fracture properties of concrete

Creep behavior and long-term strength characteristics of pre-peak damaged sandstone under conventional triaxial compression

Damaged creep constitutive models of rock-like materials containing multiple flaws and their relationships to those of the intact materials