Modeling of the creep and nonlinear damage effects of rocks and its application in tunnels

Xu, Guowen
DOI: https://doi.org/10.1007/s11440-024-02236-9
2024-02-10
Acta Geotechnica
Abstract:The creep and nonlinear damage behavior of rocks are two main factors that can cause large deformations and instability in tunnels. In this paper, uniaxial compression creep and triaxial compression tests were conducted to analyze the time-dependent and damage-induced strain-softening response of sandstone obtained from a water-conveyance tunnel in China. Using the test results, a new constitutive model was developed by coupling damage mechanics, Maxwell and Kelvin viscoelastic models, and the Mohr–Coulomb failure criterion. The model is formulated to describe both the full creep process (including the three stages of transient, steady, and accelerated creep) and the damaged-induced strain-softening behavior of the sandstone. The proposed model was validated against experimental data and was adopted to investigate the long-term safety of the segmental liner of the water-conveyance tunnel. The results showed that the differences between the rock peak and residual strength or between the initial and residual stiffness of sandstone increased as the confining pressure increased. In addition, the ratio between the crack damage stress and the peak strength increased initially with the increase in confining pressure and then decreased with a further increase in confining pressure. The ratio between creep deformation and total deformation increased with the increase in applied stress, and the specimen exhibited significant creep behavior at the final loading stage. Furthermore, the steady creep rate increased, and the viscosity coefficient decreased with the increase in loading stress. Good agreement was found between the values of failure strengths and shapes of stress–stain curves between the numerical simulation and experimental results under the uniaxial unconfined compressive creep test or triaxial compressive test. The axial load and bending moment of the tunnel segmental liner increased with the increase in the yield strength of concrete. The plot of axial force along the entire segmental liner ring varied greatly with time, while the plot of bending moment was less affected by time.
engineering, geological
What problem does this paper attempt to address?