Springback Simulation of the Inner Door Panel of the Laser Tailor-welded Blanks
Xiao-jing LIU,Ya-wei WANG,Cong WANG,Zhang-chao FENG
DOI: https://doi.org/10.15938/j.jhust.2017.05.019
2017-01-01
Abstract:In order to study the problem of tailor welded blanks (TWBs) springback in the forming process and improve its forming quality , a study on the laser TWBs of car door inner panel was made , which was about punch forming and springback.Besides, its possible defects were predicted in the forming process , then the process optimization was conducted by setting the draw bead and adjusting the pressure -pad-force.In the case of satisfied forming results, the car door inner panel was made springback analysis .Then based on this rebound results , the pattern die was carried out overall springback compensation , and the numerical simulation of forming and springback was proceeded again by using that compensated pattern die .The results showed that , through the compensation , the maximum displacement of transverse thick plate is reduced form 14.439 mm to 0.493 mm, and that transverse sheet is reduced form 7.237 mm to 3.941 mm; the maximum displacement of its longitudinal direction with flange side is reduced form 4.360 mm to 2.199 mm, and that without flange side is reduced from 3.490 mm to 1.132 mm.Therefore , after inevitable springback , the parts with surface compensation formed by the compensated pattern die are closer to standard parts than others .Furthermore , using this method , it is effective to reduce the springback influence about parts assembling accuracy , with obtaining a high quality car door inner panel cover.