Abstract:Springback is an important issue for the application of advanced high-strength steels (AHSS) in the automobile industry. Various studies have shown that it is an effective way to predict springback by using path-dependent material models. The accuracy of these material models greatly depends on the experimental test methods as well as material parameters calibrated from these tests. The present cyclic sheet metal test methods, like uniaxial tension–compression test (TCT) and cyclic shear test (CST), are nonstandard and various. The material parameters calibrated from these tests vary greatly from one to another, which makes the usage of material parameters for the accurate prediction of springback more sophisticated even when the advanced material model is available in commercial software. The focus of this work is to compare the springback prediction accuracy by using the material parameters calibrated from tension–compression test or cyclic shear test, and to further clarify the usage of those material parameters in application. These two types of nonstandard cyclic tests are successfully carried out on a same test platform with different specimen geometries. One-element models with corresponding tension–compression or cyclic shear boundary conditions are built, respectively, to calibrate the parameters of the modified Yoshida–Uemori (YU) model for these two different tests. U-bending process is performed for springback prediction comparison. The results show, for dual phase steel (DP780), the work hardening stagnation is not evident by tension–compression tests at all the prestrain levels or by cyclic shear test at small prestrain γ = 0.20 but is significantly apparent by cyclic shear tests at large prestrain γ = 0.38, 0.52, 0.68, which seems to be a prestrain-dependent phenomenon. The material parameters calibrated from different types of cyclic sheet metal tests can vary greatly, but it gives slight differences of springback prediction for U-bending by utilizing either tension–compression test or cyclic shear test.

Springback after the Lateral Bending of T-Section Rails of Work-Hardening Materials

Two-dimensional Bending Springback Analysis and Test of T-rail

Load-deflection relations of T-section rails under lateral loads

Load-deflection relations of T-section rails under lateral loads | Charakterystyki obcia̧żeniowo-odksztalłceniowe szyn o przekroju teowym poddanych obcia̧żeniom poprzecznym

Model of Straightening T-rail Based on Elastic-Plastic Theory

Residual Stress Distributions in Elevator Guide Rail Straightening

Analysis of springback for multiple bending considering nonlinear unloading-reloading behavior, stress inheritance and Bauschinger effect

Sheet Springback Prediction Based on Non-Linear Combined Hardening Rule and Barlat89’s Yielding Function

Evaluating the Significance of Hardening Behavior and Unloading Modulus under Strain Reversal in Sheet Springback Prediction

A Model of One-Surface Cyclic Plasticity and Its Application to Springback Prediction

A Constitutive Model for Spring-Back Prediction in Which the Change of Young's Modulus with Plastic Deformation is Considered

Effects of Hardening Model and Variation of Elastic Modulus on Springback Prediction in Roll Forming

Description of elastic–plastic stress–strain transition in cyclic plasticity and its effect on springback prediction

Springback Prediction Using the Split-Ring Test Based on A Combined Anisotropic Hardening Model

An investigation on springback of L-bending sheet metal forming based on nonlinear elastic unloading

Springback Prediction Model Considering the Variable Young’s Modulus for the Bending Rectangular 3A21 Tube

An Analytical Model for Predicting Springback and Side Wall Curl of Sheet after U-bending

Cyclic Sheet Metal Test Comparison and Parameter Calibration for Springback Prediction of Dual-Phase Steel Sheets

Springback prediction of titanium tube bending considering Bauschinger effect and Young's modulus variation

Analytical prediction of springback based on residual differential strain during sheet metal bending

Influences of the Evolving Plastic Behavior of Sheet Metal on V-bending and Springback Analysis Considering Different Stress States