Abstract:A tailor rolled blank (TRB) is a plate of continuously varying thickness with the advantages of lightweight, high strength, and good surface quality. However, it is required that the roll gap can be adjusted online, and the plate and roll produce large elastic deformation in the TRB manufacturing process. These characteristics make the modeling of the force and deformation parameters more difficult. A new mathematical model of roll separating force in the TRB manufacturing process is established taking into account the feature of deformation in this research. The elastic deformation of the strip and the flattening deformation of the roll are considered in order to improve the prediction accuracy of the results. The roll separating forces of the entrance elastic compression region and the exit elastic recovery region are computed using the generalized Hooke's law. A new velocity field is proposed based on the deformation characteristics of the plastic region and velocity boundary conditions, and the power functionals of the internal deformation, shear, friction, and tension are calculated. The analytical models of force and deformation parameters combined the elastic and plastic deformation regions are obtained through iterative operation, which satisfies the convergence condition of the roll separating force and roll flattening. The roll separating force data obtained by the model in this research are compared with the actual measured values in the laboratory, and the deviation value is small, which proves the computational precision of the present model. Additionally, the variations of the entrance velocity and flow volume per second during the TRB manufacturing process are shown, and the influences of the tension and friction factor on the neutral angle and roll separating force are illustrated.

Model of Straightening T-rail Based on Elastic-Plastic Theory

Modeling, simulation and experiment for straightening lateral bending of elevator guide rail

Load-stroke Model for Straightening the Warpage of T-rail

Key technologies of vertical press-straightening of elevator rail

Residual Stress Distributions in Elevator Guide Rail Straightening

Two-dimensional Bending Springback Analysis and Test of T-rail

Load-deflection relations of T-section rails under lateral loads

Load-deflection relations of T-section rails under lateral loads | Charakterystyki obcia̧żeniowo-odksztalłceniowe szyn o przekroju teowym poddanych obcia̧żeniom poprzecznym

Springback after the Lateral Bending of T-Section Rails of Work-Hardening Materials

Three-dimensional Finite Element Simulation on Moving Load Induced Track Response over Stiffness-varied Base

Four-Point Bending of Basic Rails: Theory and Experimental Verification

Research on optimization of basic rail top bending prediction model

Study on key technologies of straightening large-scale integrated part's distortion due to machining

An elastic-plastic theoretical analysis model of wheel-rail rolling contact behaviour

Three-dimensional elastic–plastic stress analysis of wheel–rail cyclic rolling contact using finite element method

FEM ANALYSIS ON THE ELASTO-PLASTIC PERFORMANCE OF THREE-POINT-BEND SPECIMENS OF RAIL STEEL

Forming process model of rail corrugation based on friction induced torsional vibration determined by vertical dynamics

Process Modeling and Stroke Calculation for Shaft Straightening

An investigation into Belgrospi-like damage formation on a sharp curved track using finite element method

A geometrically exact discrete elastic rod model based on improved discrete curvature

Mathematical modeling and analysis of the tailor rolled blank manufacturing process